开云体育

I've just attempted to load a landscape ch5z project onto a 1070 and for some goddam reason when it restarted it's in portrait mode.
I can't see anything in settings to reset this and there is no device extender to correct it.

?

Any ideas?

LCDORIENTATION consosle command?

On Sat, Feb 1, 2025 at 02:56 PM, ZS wrote:

LCDORIENTATION

Thanks,

If only:

You sure it is TS-1070 and not TSS or anything else? Otherwise maybe new firmware disabled this command.
You can also try typing LCD and then hit the TAB key for auto complete in case it was renamed slightly.

Oh, It's defiantly as TS-1070.

Brand new, only been using it about 5 days and had been working fine until this morning.

That was the time when it connected to a TST-1080 hardware definition. There's a device extender in the 1080 HW definition where you can set its orientation. Get that programmed, bring your 770 online on that IP ID again and change it back.

I did try that as well.

?

And yes you are correct, I'm using the 1070 on a TST definition, however there was no programming to change the orientation.?

I added reserved4 extender this eveing and set orientation to 1d and no dice.?

Just tested with my 770, you need to send 2d to bring it back to the correct orientation.

So in the end

* init/restore

* Then sending 2d to orientation

?

Sorted.

Thanks