开云体育

I have a misbehaving scaler on my hands. I bought it second hand. Upgraded the firmware. Tested it. Everything was fine. Then I installed it in its new home and its behaving strangely. It shows up in Toolbox with Device Name: C2I-DMPS-200-VIDEO. After several reboots it may come back for a little while and look like a regular?DM-RMC-SCALER-C. But say if I update the IP Table, it reboots and goes back to calling itself C2I-DMPS-200-VIDEO.

It is connected to a DM-DA4-4K-C which is connected to the HDMI output of a DMPS3-200-C.

I have a second?DM-RMC-SCALER-C connected to the same DM-DA4-4K-C that works just fine.?

I'm not sure how this misbehaving device got into this state, or how to get it out of it. I am grateful for any ideas you may have!

Pure guessing:

Does the DM-RMC-SCALER-C by accident have the same IP address as the video card of the DMPS?

Best regards
Crestronfreak55

Oh my goodness, yes, it looks like that's what happened!?

I didn't realize that the DMPS audio and video took their own ip addresses. I just happened to assign a dhcp reservation to the scaler that was the same as the DMPS video ip address. Whoops!

Thanks for the tip. I'll never make that mistake again!