I believe there is. Which module are you using to control the webex device? (guessing it's a codec).

If you are using the Cisco Room Devices 4.0, I believe that device has "message center" or "alert center" control sections, which may allow you to enter credentials. I have not had to use this yet, however, so I may be completely wrong.

Is there a way to change the HDCP support of DM chassis input cards via Text Console? I know DMHDCPdisplay shows the current HDCP info per card, but is there a way to use text console to turn support on/off?

I work with systems that have 1-2 outputs connected to capture cards, so I need to be able to turn off HDCP support - which gets turned on upon firmware upgrades. I know I can do this via DM tool, but that tool takes forever to load.

Thanks for any info!

Hello Daniel,

?

I mean that when you start a webex meeting through the cisco panel, some pop ups appear asking if you are a host or guest to continue.

I am reviewing the api guide to see if I find something to be able to replicate it in the Crestron panel.

What do you mean by "reflect"? Do you want the popups to show up on a panel?

I am also curious, but I am hoping to close out the prompts. Hope we both can get some info.

Sorry for the off topic post.? ?Let me know if you have one you're not using.
Thanks
Karl

Hello everyone,

?

Does anyone know if there is a way to reflect the pop ups that appear when you make a call through a webex room kit in a Crestron panel?

?

Thanks in advance

I think that's a valid point, there's no reason to pull up calc.? In the case of the apple remote, with the later IOS, that's just a swipe down from the upper right corner.?

Unfortunately it is not possible. Poly G7500 always reboots when provider mode changes.

Talk to coolautomation support, they can update the unit's firmware remotely to the latest v, which if i remember correctly, is not available for us to download.

R is for Residential

Yeah have also done this for a client that wanted an analogue clock. Activity detection and touch detection through a pulse stretcher or'd together did the trick.

sent you my email address

To answer the original posters question -- No you cannot run SIMPL on a CP3-R.

The CP3-R was a pretty short lived processor.? It was available for just a short period. Being introduced in 2019 and discontinued in 2020.? We ordered one by mistake not realizing it couldn't do SIMPL.? Crestron came out with the CP4-R (I believe in 2020) and as a result discontinued the CP3-R.

"...It's only a movie...only a movie...only a movie..."

But I use non -R for residential I dont need no stinking CH bs haha. Theyre trying to brainwash us lol

开云体育

Its for Residential.

I think that the 'R' means lots more RAM, needed for the Pyng/CH apps...

Also note, I don't think that there's any way to use the 'R' version for standard SMW projects...:(

Always curious why they used the suffix "-R" for these devices instead of -P (pyng) or -H. Is R some kind of internal code name?

Hey John,
I haven't fully thought this thru yet, but I think that if you just set up the streaming ports on the NAX units to a separate switch and then use the other/non-streaming ports for control on the main network - basically a hardware wall between the two communication types...
This is not the ultimate solution, but it could get you done for now...

Tom Brady (not the Quarterback!) at Crestron would be the guy to review this with, Send me an email if you want his contact info...