开云体育

Have you set an address in the display? The default is 00, and I’ve found displays can be “wonky” if left at default (the specific wonkiness depends greatly on the specific display and firmware

What was latest on this issue, were you able to get this working? I just got a couple of these in and am experiencing the same results. I have connected directly to the display using the providing

Or what about the speaker wires running to the touchscreens?

Can anything be done to ease to pain of a transition from Colorado vNet to Crestron? Any way to talk to any of the vNet gear? Know of a way to get the vNet software?

That's my hood, I'll talk to some folks. Something may come up. Feel free to bounce some neighborhoods off me if something comes up. DC is getting alot nicer, with a steady declining crime rate. The

Thanks everyone. Yep, 3-series. This is officially my first 1-based startup problem. Yesterday, when head explosion was impending, I tried driving the ARAM recall on a delay. No luck. Today, with

My girlfriend has been offered 7-ish week internship at the Library of Congress in DC from August 4th - September 24th (I think) to satisfy a requirement for her Masters. Unsurprisingly... housing in

Yes had to write one, if you need it please contact me.

"If this display is getting controlled by a app through ios. Then it is accepting the commands over LAN, so it can be controlled by crestron over LAN." Unless the iOS app is using any kind of secure

Yes had to write one, if you need it please contact me.

Does anyone have a module for a extron dmp 128. Kind regards

I've been doing program running > is for a pulsed digital > set reset latch that outputs a signal called "high" and "low". I use those in place of 1/0's. One shot also initializes variables.

since a very, very, very bad day with a program. I never use the 1 on any symbol. a set/reset latch or a toggle symbol do the job. for the module who polling device status, same thing or I'm using the

Crestron trainers are now telling people not to use 1 with 3-series processors. I'm not sure if this is official or unofficial but... 1 should still be ok on things that enable gates like a input on a

if you wait a time before trigging does it work? at boot up I'm using a simpl+ module who only have a a wait for initialization to complete() in the main section of the program and pulsing a digital

What if you do a delay/stepper for the recall like Phil stated? Do you get the same results with the ARAM?

Hey all, have a project with a TPS-15 connected through an IADS to an IIF Doorstation. That same Doorstation also feeds a Barix which works brilliantly with TPMC-8L panels. The TPS-15 however seems to

3-Series processor by any chance? I've seen similar with an MC-3 but haven't had time to chase it up with TB. I triggered the recall from a stepper instead. Cheers Phil

If this display is getting controlled by a app through ios. Then it is accepting the commands over LAN, so it can be controlled by crestron over LAN. Regards Mayank 9892553421 Sent from BlackBerry?

We have a panasonic display which can be controlled with a Panasonic Remote TV2 App on ios. Can this Display be controlled with Crestron on IP or CEC. Any help would be greatly appreciated. Thanks