开云体育

As a follow up.? I purchased a TSR-310 connected to Crestron Home.? I've been using it for about a week and it has performed really well.? It's running the latest firmware and connected to my 5ghz

Thanks for the help! That was a perfect solution! I was looking for a single extender just for those sensors, and a name like Occupance_Sensor... Glad to know it is possible and people will point you

I think the Cresnet port -IS- available on a 3-series processor in Slave mode.? Answer ID 5232 describes it, and I'm fairly certain I've done it before.

Trash the OOTB, unless you like the scrolling lists of doom.? I set up many of these just fine with a basic simpl program, a few idiosyncrasies to deal with, but solid if you don't ask them to do too

EISC for sure.? I'd put only my button presses and feedback to the CP3, and do any lighting logic local to the mc3. I'm not sure you can use an eslave device's gateway, I know you can't use it as a

yep that was it. thank you!

Try using 127.0.0.2 for both programs/slots.

I've done this before but its been a very long time. My understanding is you put and EIC in each program in the same IPID and set the ip address to 127.0.0.1 for slot 1 and 127.0.0.2 for slot 2. for

Like Fabio said, definitely delete the SplWork folder. Also, If you're running the program with local "Project" modules vs from your library, this also might account for not seeing the update if you

That does seem like a potential solution. Although, again, I verified that all the output files had current date stamps. But something wasn't getting triggered. I now kinda hope I see this issue again

I am trying to find a IR Code for the HDBT Input.. Any Ideas anyone?

Hi Terry, Also try the "Recompile All" from within Simpl+ (located on the "Build" menu). Again, this is within SImpl+ and not SimplWindows. For me, there have been occasions where a small modification

Your idea is the best, cresnet is about 38400 baus rate, super slow. You can also try the EISC but it will requiere having two running program and get things synchronized

I would make the MC3 a slave. That way all of the IOs including the EX gateway will be available in the CP3. I am embarrassed to say that I am not sure about the cresnet. I would assume that would

Hello, Here's my setup, I replaced a MC3 with a CP3N (RS-232 and the three IR functions have been moved over from the MC3)?but I also have a Crestron CLW-DIMEX-P controlled by the built-in MC3's

Thanks Lincoln! I had the same thought but without the product in front of me, I was not sure. There is a camera module from Crestron in the database but it’s for a single camera. Looks like I would

I have not used it but based on the description in the manual I think for manual control you'd probably want to recall the preset to force camera 1 (or camera 2) output and then only worry about

I didn't try that. I didn't even think about it as never use it. It *shouldn't* have made a difference as I know I was compiling the S+ module in question. But, I suppose it might have forced the main

Anyone use the two headed 1 beyond hawk camera? If so, I am interested in how to managed the manual control. I assume you would address each camera head and control each with separate modules….

Did you use 'Recompile ALL' (Alt-F12) or Recompile all from the Project drop-down? This is the only way that I compile programs now so I don't have to think about it...:)? ?(It might take a little