开云体育

Does anyone have an RS-232 or IP module to control this unit? Thanks Don

Is the module completely Simpl+? Having not used a MC3 yet all I can tell you is that if you are using anything that uses ticks for timing it will cause timing issues. This is because a tick in the

Any luck learning this, the remote that came with my hopper is rf only, no switch in the remote battery compartment

If I have more time on a next project with this remote I will give it a tried again within SIMPL side, but this project is not in time frame to test.

Except there is no vcbutton command and the camera command doesn't have a for-content option in the QDX.

I also prefer to keep stuff like this in Simpl, because it's easier to make changes later - especially if there are multiple remotes or touchpanels.

I want to see the commands been sent from a controller, then copy those strings to use from Crestron. You suggesting running the controller through the com ports on a processor (QM-RMC, connect A to

Well, I just updated the PTX-3, with the hard button manage assigned the joins to proper command EX: join 10= Cable box #1. and work OK, so far, the only problem is that takes time to goo true all the

I started out using the hard button manager but have switched to buffers. I have found it makes it easier to transition between different remotes or touch-panels and not have to redo all of the code.

What do you mean ? a nice qm-rmc :P

Can anyone recommend a good serial port sniffer?

Use either one you want, there's no functional difference. I prefer buffers personally because I'm used to hardbuttons always sending the same joins, and when I reassign them I tend to forget about

Hi All, I have a Simpl+ module that I wrote for an IP controlled device, it works fine with my Cp2E processor in the office. - However - when It got sent out to a client site that has an MC3 in it -

For the content issue you need to assign the correct camera for the content in hdx7000 the content camera is input 3, just sent those command: vcbutton map 3\r camera for-content 3\r if the

They have a conference software suite to control the microphone system, which can link up by either com or lan. Is there a way I could see what commands are being sent? That way it would help my

Never program a QDX Unit but i've done some hdx7000 thru tcp/ip with success. Using port 24 work great. (Need to sent the password to be able to control it via tcp)

Make sure you don't have a florescent light on over the receiver. Without having an IR emitter cover in place, the florescent light will wash out the IR signal. James

Is the box currently in RF mode? Do any commands work at all?

Crestron still sells them, I got a few the other day.

Last night my Crestron mobile updated on my Android. Today when I launch it I get a message that says "A newer project format has been detected. Please update your software to enable new project