Hello,

Could anyone explain to me how the serial outputs on the FIFO Queue symbol are supposed to be fed data? I have read the help file and am running in to an issue understanding the signal routing; My serial outputs always display empty.

My understanding is that it takes data from a Serial RAM symbol, so I put together a quick program that has a FIFO Queue, and MakeStringPermanent, and a Serial RAM symbol. I have digital signals called Select_1 through Select_5 on the inputs of the FIFO and the SRAM. The FIFO has serial outputs called Display_1 through Display_5. The In/Out signal on the SRAM is called Serial_Ram$ . In Debugger, I can hold "store" high on the SRAM and populate strings in to it. Then I can set "store" low, and "recall" high, as well as setting "enable" high on the FIFO queue. At this point I can see all the digital presses of selects queued properly via the FIFO, and the proper serial strings are recalled on the In/Out signal from the SRAM, but the Display_1 through Display_5 outputs on the FIFO are always blank.

I feel I must be misunderstanding something, but Crestron TB couldn't help either. Is anyone familiar enough to explain or point me towards a program or module that uses this symbol with serial data that I could review?

Thanks!

Joshua Blanton

开云体育

开云体育

============================================================================
Please refer to http://www.eeny.net/disclaimer.txt
for important disclosures regarding this electronic communication.
============================================================================

So after struggling with this it is time to finally cave in. ?Has anyone come across these boxes yet and if so have you found the location of the IR sensor? ?This is Comcast new X1 or should we say X2 platform that has the cloud based DVR. ?Ran into this box on Friday afternoon and was able to get the standard IR codes to work but can not get it to work with an IR bud on the front of the box. ?Using an MX-850 being converted to a Crestron ML-600. ?Tried every possible spot on the box firing codes at it but nothing worked until I set the remote to just IR and not RF. ?Finally just programmed the Comcast remote to work via RF but need to find a solution. ?I was able to find the IR sensor on the front of the slave Verison 2 Xi3 box.

Thanks,

Pat

+1, hot on the relay.

Better control over rs233 or ethernet.? The last sx20 i? have integrated have the tablette control. After setting up the tablette. The IR remote stop working.

My 0.02$

Hi everyone,?

I hope you are doing will,?

I have Cisco SX20 (Video Conference) and i need to control it with crestron throw CSP-LIR-USB IR learner?
because right now i am in case that i can not use another method to control,?

can i control it easily by ir learning and then control it throw crestron touch screen ?
or i will face some problems ?

any one have an experience with this case , can give any information can ?benefit me ??

thanks all?
?

开云体育