开云体育

I agree. The Batteries, are very important. DO NOT "Hot Swap" the RF Module, they are fragile.

Has anyone been able to do this? Apparently, you need to write a TLS console connection to the UC which then allows you to send "reboot" via the console (like via Toolbox) This connection needs

Hello tribe, Is there any easy way of getting a simpl controlled third party device into XIO? There is no certified driver for this very make/model but a rather trivial TCP-protocol on port xxx.

You need to search (in a loop) for a string starting with a Space and ending in .mov Then locate the \x0D\x0A delimiter in that new string and remove just the chars after the delimiter which is the

something like Function ParseLine(string line) { filecount = filecount + 1; filenames[filecount] = remove(" ", line); } change rx$ { string line[100]; while(1) { line = remove("\n", rx$);

Thanks for the hints. I tried the raw hex into a discrete serial send so I didn’t have to change much. Took a few different ones but finally got it. I appreciate the assistance.

Hi Maraldi, I had a different issue with that module. I used it last week it was running with the ATEM 1M/E Production Studio 4K. I was able to control the device but it was not that reliable,

Can’t say it was a QB75R but done tons of QB displays via serial. We use a heavily whacked down version of the Crestron module in the DB for an ancient model (400? 460?) mainly because on a certain

Crestronfreak55! good night I tried to use your module but I wasn't successful I changed the ip as mentioned but there is no control over it. the variable initialization$ is in the state =2 but the

Has anyone had luck controlling the Samsung QB75R display with a 232 module? I have tried the 460utn-ud one on the application market with no luck. That same module did work for the UM55H-E displays I

Got it resolved. Had to restore the 4 350's and re-setup. Work fine now, strange issue.

Remove the batteries from the lock, then remove the RF unit from the lock, then, Put it back in and lastly, put the batteries back in. Number 7 option should become available once the lock reboots.

yes I can access them from their GUI, and get streams going directly through GUI from some E30's no issue.

Are they on the same subnet? wrote:

I have also changed the IPID in the program and associated offline NVX350 and recompiled etc to no avail.

Hello again all, I am having a heck of a time with 4 NVX units out of 17. These 4 units are refusing to go online in the IPTable as well as don't show up in Device Discovery Tool, but I can connect

Have 5 Crestron Yale Locks need them to acquire to their CEN-GWEXER Gateways. Following Crestrons documentation Acquiring the lock: To acquire the Yale lock?you must enter Menu mode.? Follow these

Hey everyone, Normally Id sit and figure this out but I'm under the gun and haven't done parsing in forever. I'm sure someone here can figure this out in 5 mins...haha I need to pull the file names

Top right.? Under your login. -- Ryan Baldwin *CEO | XS Design Studios* rbaldwin@... 760.712.2240

i'm having trouble with the WebEx Room controller v4 module. It works for up to about a week, then the call connected feedback stops going high while in a call. One fix is to issue progreset command