Hi Jay,
?
Happy New Year!
?
Unfortunately, the Shelly 1 + Add-On combo doesn¡¯t seem to support sensor reporting via URL.
There?s no ¡°Report Sensor Values" option.
The Shelly H&T Sensor isn?t an option IMHO since I prefer to have invisible sensors with no maintenance.
The H&T is another ¡°thingy¡± standing around needing support from time to time replacing batteries (even if it?s just once a year).
?
So I?ll approach Allterco and ask them if it?s possible to add the sensor reporting to the Add-On/1/1PM.
?
Cheers,
Thorsten
?
?
Hi Thorsten,
First, the Humidity-Temperature Sensor v1 module is for the Shelly Humidity-Temperature sensor.? I'm not sure that I ever tested that with a sensor connected to a Shelly 1/Shelly 1PM.?
I'm trying to reproduce your setup to see if I can make it work.? Unfortunately, the temperature sensor adapter I have for the Shelly 1 and Shelly 1PM appears to have a problem.? As soon as I plug it into a Shelly device it crashes it.?
When I view the built in web page for the Shelly Humidity-Temperature Sensor there are 2 sections for URL actions.? The first is Sensor URL actions.? This is where the entries for over temp/under temp and over humidity/under humidity are located.? However, there is also a section called actions.? Under the actions section is where "Report Sensor Values" url action is located that is needed to report temperature and humidity updates to a Crestron processor.
If this isn't included with the Shelly 1/Shelly 1PM then I'm sorry there isn't a way, without writing additional HTTP code to poll those values, to make it work for you.?
The Shelly H&T Sensor is under $30 so that may be the easiest path.
Hope this helps
Jay
?
On 12/31/2021 10:44 AM, Thorsten K?hler wrote:
Hi Jay,
?
i?m just testing with the Shelly Add-on board and an attached temperature and humidity sensor.
The Add-On board is attached to a Shelly1.
Sensors are recognized by the Shelly1 and working ¨C temperate and humidity is reported on the Shelly?s web-interface.
Now i?d like to integrate these values into my Crestron system.
I?m using the latest v8 package of your Shelly modules.
?
In the help for the ¡°Humidity-Temperature Sensor v1¡± module, it says:
¡°For the module to properly refect the feedback the following
fields of the Shelly I/O URL Actions must be set:
1) Humidity-Temperature Sensor Report Sensor Values URL
This field should be set as follows where Processor_IP and
Processor_Port must match what is set in the Shelly Comm Manager
module.?
?
¡±
?
The problem is, that I don?t have a ¡°Humidity-Temperature Sensor Report Sensor Values URL¡± setting under ¡°Shelly I/O URL Actions¡±.
I do have the described over and under events, but nothing for the actual readings for temp. and humid.
?
Shelly firmware is the latest (updated today).
?
Any idea?
?
Cheers and a Happy New Year to all on the list!
Thorsten
?
