I have now made a connection to the idoc via serial cable and then by using the toolbox device tree view and the correct com port.
I then right click on the idoc device and select functions.... Where do I go from here to make this device discoverable via the composer wizard.
If I select Ethernet addressing it shows IP address as 192.168.0.4 with dhcp not ticked.
Or if I select ip table setup it shows me ...
Ip Id 05. IP address 192.168.000.002
What and where do I need to enter this info
I've gone back into the adagio composer and made the idoc ipid 05 as it originally said ip id 03 here then what should I do next?
Thanks to anybody that can point me in the right direction
toggle quoted message
Show quoted text
--- In Crestron@..., "jimathome80@..." <jimathome80@...> wrote:
I've not managed to set IP address yet. I have serial to rj11 cable from pc to idoc and then using view port select the same connection that I originally used to find IP address of aads then I run the wizard but the next screen shows a yellow dot next to idoc saying that's its not discovered! Could the com port setting have changed on my pc?
--- In Crestron@..., Phil Bridges <gravityhammer@> wrote:
Have you set an IP address in the iDoc? IIRC, you have to do that manually
using the supplied serial cable.
On Sat, Apr 27, 2013 at 9:22 AM, jimathome80@ <
jimathome80@> wrote:
**
Hi
Can anyone help?
I'm trying to setup a simple system of an 1 x aads 1 x tps4l and 1 x idoc
in adagio composer/system builder.
The problem I'm having is I'm unable to see the idoc when I use the device
discovery wizard. I've set up ip communications between the aads and then
crestnet commutation with the tps4l on an I'd of 03 but it asks for the
serial number of idoc?
All equipment is connected to my router what am I missing or doing wrong.
Sorry in advance for the basic question...
[Non-text portions of this message have been removed]
