开云体育

Have you replaced your SP/I contactor to solid state? It does sound like a good idea. I've just sent an inquiry to Bohlinger about the F/R contactor. Thanks, Mark

That is the speed controller. As you push on the throttle there are actually 3 speed the controller sends different voltages to the motor. Yes it can easily be removed. Be careful if you file the

I got mine from : BOHlinger, Inc. 600 E. Elm Street Conshohocken, PA. 19428 Phone: 610-825-0440 Fax: 610-825-2730 It was 60.00 shipping. Yes it was pretty much a direct replacement. Bob

I agree! Dale's car is insperational! C-Car@...> wrote:

Dale, do you still have you yellow dream machine? Looks neither of us has won the lotto. Sure is a sweet ride!

Have another Contactor question. Looking at the contactor diagram in the service manual it looks like the taller one is the Forward Reverse Contactor, the smaller one is labeled SP/ I contactor. What

Where did you get the Contactor from? Was it a direct replacement and how much did it cost?? Thanks, Mark

Brushed stainless wrapped over wood for me. wrote:

I used rubber parking stops (4 feet wide) (looks like the concrete ones but black) mounted on a 2 x 6. It makes a pretty nice and reflective bumper.

I have looked back 10 yrs of this site and unable to find anything or may have overlooked it but what is everyone doing to replace the old rotting out bumpers on the Citi Car. Mine have become brittle

Thanks Dave for the reply! I attached a low res picture of my set up because you mentioned about mounting the main contactor horizontally, it needs to be vertical? And I placed the saved 12 volt

And... I left the reverse and forward input open and used the original setup. Controller doesn't care.

Hey Tony, I wired mine last year, so I still remember a bit. Sounds exactly like my setup. For the 48v controls I used the old resistor relay to switch 48v on off from 12v key switch. That runs to the

Good morning All, I'm at a standstill with my upgrade. I bit the bullet and got and installed a new SR48600 controller, heavy duty main Contactor, f/r contactor, and PB-6 pot box. I have the high

They are the manufacturer but the info page is here: https://www.carlingtech.com/rocker-switches-tg-ltg-series [C-Car] <C-Car@...> wrote:

I did not. I will look them up. That is great news. [C-Car] <C-Car@...> wrote:

I'd be interested in getting 6 or so. Do you have the link for Carling Technologies? Bart

Did you try glean at EVperformce I know he has them in stock Sent from AOL Mobile Mail Get the new AOL app: mail.mobile.aol.com

Hello all, Our 76 Citicar has degraded to the point of being a not raining, daylight-only vehicle because all of the original rocker switches have failed. I am going to contact Carling Technologies to