开云体育

I'm excited! I doubt I'll get in in tonight. [email protected]> wrote:

Hi Dave and All,? ?? They come vented with an internal fan and have blower port options to attach a hose to. They build these custom to each customer so you can order about anything you want.?

Also, depending on where you live... I'm expecting about $625 +100 shipping. Approximately. based on the quote. [email protected]> wrote:

It has venting, but I'm likely going to loose my heat. I may be able to plumb it, but I'm not totally sure at this point. With that said, it will have no issue cooling itself, just maybe not providing

Dave, Sorry for the slow response, I was not ready to pay the $800. How are you going to connect the air port? Or does it have it's own cooling??-- Cheers Tony P 1980 Orange Comuta-car

I should also mention I asked to leave the tail shaft to be left on to allow speedometer to be installed if I figure out how to do that. I'm excited. they should start on it monday if all goes

Ok I had to make an order so I can get rolling. My car gets a new model number from d&d es40c-56. My centering ring is off from their common motors, and that model number is a combo of a couple

Thank you Tony.

The Dana axle mounts the motor on the front of the axle, being towards the interior of the car. The cars with the Dana have a different designed battery box to fit the motor position. I also think the

I'd be interested in a group buy if that happens. I have a similar 600a alltrax, and 2 ga wires. I have not yet verified my axle ratio as 5.17 or my tires rolling radius somewhere around 10 in.

I have the alltrax 48v 600a controller. 2/0 wiring. I use a kilo vac 500a 320v disconnect if it all hits the fan.?The sales order from D&D is 16000434 invoice is INV1600457 the motor is the

? ? ? ? Hi All,? ? ? ? ?? Just got through talking to Eric at D+D and motor cost about $565 depending which model and 500 amp 72vdc controller about the same. 1 315 701 0635? ? ? ? ??

? ?? Hi Tony and All,? ? ? ?? Very likely they will do a group order discount.? ? ? ? ?? I'd suggest going the next size up motor, 150-175 amp as stock was a little light especially if

Crazy idea All, Could we get a discount for a group order? I wonder if EV Performance site could stock them? I know I would have already purchased one if I knew it was a perfect fit upgrade. Let me

https://ddmotorsystems.com/ -- Cheers Tony P 1980 Orange Comuta-car

Thank you for tip on replacement Comutacar motor. Does d&d have a website ? Telephone contact?Regards?Howie

Thanks Nicholas and Dave, I'm interested in getting the the forced air option done too. Is the citi car connection to the Dana the same as the 1980 Comuta-car? If so I'd like to get the sales number

My D&D motor was custom made from a stock citicar Terrell axle motor. They actually had 2 in stock. But mine was milled on the shaft side to vent and on the far side to allow a 2" hose for forced air

Tony, I dont know all the answers. However there are some "newer" motors that may be sepex or ac that use 10 spline. It is a different 10 spline! However, many older carts took a 10 spline, on the

Good morning all, I believe a similar thing happened to me, but I have a question that may or may not have been covered. Will any club car 10 tooth spline motor fit a 1980? I want to replace the 40