|
Can I use BPQ32 (linbpq) to gate tcpip over an AX.25 radio port?
?
Thomas
|
Yes, See
73, John
On 02/03/2025 23:17, Thomas Bostr?m
(SM0YOS) via groups.io wrote:
toggle quoted message
Show quoted text
Can I use BPQ32 (linbpq) to gate tcpip over an AX.25 radio
port?
?
Thomas
|
Do I need Amprnet or can i user public internet?
?
73
Thomas
|
It sounds like aprnet is not required for your application. The thread below may be helpful.
73, Lee K5DAT
On Mon, Mar 3, 2025 at 4:43?PM Thomas Bostr?m (SM0YOS) via <thomasbostrom1= [email protected]> wrote:
Do I need Amprnet or can i user public internet?
?
73
Thomas
|
No, you don't need amprnet. How are you planning to use it?
73, John
On 03/03/2025 22:43, Thomas Bostr?m
(SM0YOS) via groups.io wrote:
toggle quoted message
Show quoted text
Do I need Amprnet or can i user public internet?
?
73
Thomas
|
I plan to run tcpip between two linbpq nodes over a 9600 baud link.?
I want to access the internet from the node that does not have internet, only radio connection
Is it possible?
?
73
Thomas
|
Yes, that should work.
73, John
On 04/03/2025 09:17, Thomas Bostr?m
(SM0YOS) via groups.io wrote:
toggle quoted message
Show quoted text
I plan to run tcpip between two linbpq nodes over a 9600 baud
link.?
I want to access the internet from the node that does not
have internet, only radio connection
Is it possible?
?
73
Thomas
|
Following i need to do the same thing!
Thanks
toggle quoted message
Show quoted text
On Mar 4, 2025, at 4:55?AM, John G8BPQ via groups.io <john.wiseman@...> wrote:
?
Yes, that should work.
73, John
On 04/03/2025 09:17, Thomas Bostr?m
(SM0YOS) via groups.io wrote:
I plan to run tcpip between two linbpq nodes over a 9600 baud
link.?
I want to access the internet from the node that does not
have internet, only radio connection
Is it possible?
?
73
Thomas
|
"over a 9600 baud link. I want to access the internet
Thomas and Bob: Is 802.11n,ac possible? Near line of sight? Legal in your country? ? 2 commercial outdoor rated 802.11n,ac router-radio-antenna devices would likely be much cheaper than 2 ham radios, 9600 baud modems, antennas. ? 73, Chuck
|
Or a pair of NPR modems at ~500kbps assuming you're NOT in the USA where we are crippled at just 56k.
"over a 9600 baud link.
>>> I want to access the internet
Thomas and Bob:
Is 802.11n,ac possible?
Near line of sight?
Legal in your country?
?
2 commercial outdoor rated 802.11n,ac router-radio-antenna devices
would likely be much cheaper than 2 ham radios, 9600 baud modems, antennas.
?
73, Chuck
|
For me no, we don’t have clear line of sight to our repeater site, so in needs to be uhf or vhf.
Bob
toggle quoted message
Show quoted text
On Mar 4, 2025, at 10:01?AM, Chuck Gelm <nc8q-aredn@...> wrote:
?"over a 9600 baud link.
I want to access the internet
Thomas and Bob:
Is 802.11n,ac possible?
Near line of sight?
Legal in your country?
?
2 commercial outdoor rated 802.11n,ac router-radio-antenna devices
would likely be much cheaper than 2 ham radios, 9600 baud modems, antennas.
?
73, Chuck
--
Bob
va3rjs
|
On 3/4/25 10:58, Bob-va3rjs via
groups.io wrote:
For me no, we don’t have clear line of sight to our repeater site, so in needs to be uhf or vhf.
Bob
On 3/4/25 10:01, Chuck Gelm wrote:
Near
line of sight?
3s, Chuck
|
And so a pair of NPR modems (with TRX built in!!) on UHf should work.
I built mine from the gitHub repo and saved a little $$$. They do 56K up to 500Kbps depending upon how they are configured.?
Mark / NI2O
On 3/4/25 10:58, Bob-va3rjs via
wrote:
For me no, we don’t have clear line of sight to our repeater site, so in needs to be uhf or vhf.
Bob
On 3/4/25 10:01, Chuck Gelm wrote:
Near
line of sight?
3s, Chuck
|
I have tryed this config without success, no answer when pinging 192.168.0.114 from the client.
Probably missed a lot....
?
Client bpq node SG0YOS without internet connection? ? ? ? ? ? ? ? Server bpq node SE0YOS with internet connection
The node has wifi AP and I connect the pc via wifi? ? ? ? ? ? ? ? ? ? ? ?eth0 ip address 192.168.0.114
wan0 has address 192.168.5.1, no address on eth0
config:? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? config:
IPGATEWAY? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? IPGateway
Adapter wlan0? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? Adapter eth0? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ??
44ENCAP 192.168.1.10? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ?44ENCAP 192.168.1.10? ? ? ? ?
IPAddr 192.168.5.1? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? IPAddr 192.168.0.114? ? ? ? ? ? ? ? ? ? ? ?
IPNetmask 255.255.255.0? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ?IPNetmask 255.255.255.0? ? ?
IPPorts 3? ? ? ? ? ? ? ? ? ? ? ? ? ? # Nino tnc on port 3? ? ? ? ? ? ? ? ? ? ? ? ? ? IPPort 3? ? ? ? # Nino tnc on port 3? ?
ARP 192.168.0.114 SE0YOS 3 D? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ARP 192.168.5.1 SG0YOS 3 D??
****? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ****
?
73
Thomas? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ?
?
|
After starting linbpq i ran this commands and then it works
?
sudo ip route add 192.168.0.114 dev LinBPQTAB? ? (on sg0yos)
and
sudo ip route add 192.168.5.1 dev LinBPQTAB? ? ? ? ?(on se0yos)
?
Probably wrong way to do it but couldn't run these commands
in the IPGATEWAY configuration.
?
/Thomas
|
On Wed, Mar 5, 2025 at 11:22 PM, Thomas Bostr?m (SM0YOS) wrote:
?
Is there any way to specify
sudo ip route add 192.168.5.1 dev LinBPQTAB? ? ? ? ?(on se0yos)
in the IPGATEWAY config with the route command? ?
73,
?
Thomas
|
No, you'll have to do that on Linux.
73, John
On 08/03/2025 07:32, Thomas Bostr?m
(SM0YOS) via groups.io wrote:
toggle quoted message
Show quoted text
On Wed, Mar 5, 2025 at 11:22 PM, Thomas Bostr?m (SM0YOS)
wrote:
?
Is there any way to specify
sudo ip route add 192.168.5.1 dev LinBPQTAB? ? ?
? ?(on se0yos)
in the IPGATEWAY config with the route command? ?
73,
?
Thomas
|
Hi John,
??? About a shell command in your next version?
73 de Jean
On 2025-03-11 03:27, John G8BPQ via
groups.io wrote:
toggle quoted message
Show quoted text
No, you'll have to do that on Linux.
73, John
On 08/03/2025 07:32, Thomas Bostr?m
(SM0YOS) via groups.io wrote:
On Wed, Mar 5, 2025 at 11:22 PM, Thomas Bostr?m (SM0YOS)
wrote:
?
Is there any way to specify
sudo ip route add 192.168.5.1 dev LinBPQTAB? ?
? ? ?(on se0yos)
in the IPGATEWAY config with the route command? ?
73,
?
Thomas
_._,_._,_
|
I'll think about that though there may be security implications.
73, John
On 11/03/2025 12:42, Jean Létourneau
via groups.io wrote:
toggle quoted message
Show quoted text
Hi John,
??? About a shell command in your next version?
73 de Jean
On 2025-03-11 03:27, John G8BPQ via
groups.io wrote:
No, you'll have to do that on Linux.
73, John
On 08/03/2025 07:32, Thomas Bostr?m
(SM0YOS) via groups.io wrote:
On Wed, Mar 5, 2025 at 11:22 PM, Thomas Bostr?m (SM0YOS)
wrote:
?
Is there any way to specify
sudo ip route add 192.168.5.1 dev LinBPQTAB?
? ? ? ?(on se0yos)
in the IPGATEWAY config with the route command? ?
73,
?
Thomas
|
IIRC FBB used to have a "superuser" auth mechanism where a connected station would be challenged with a password prompt. The prompt was not looking for the whole password but rather a random assortment of the characters in the password. If the password was "LetMeIn" it might ask for "3417" and expect those corresponding characters to be returned.
Just a thought?
I'll think about that though there may be security implications.
73, John
On 11/03/2025 12:42, Jean Létourneau
via wrote:
Hi John,
??? About a shell command in your next version?
73 de Jean
On 2025-03-11 03:27, John G8BPQ via
wrote:
No, you'll have to do that on Linux.
73, John
On 08/03/2025 07:32, Thomas Bostr?m
(SM0YOS) via wrote:
On Wed, Mar 5, 2025 at 11:22 PM, Thomas Bostr?m (SM0YOS)
wrote:
?
Is there any way to specify
sudo ip route add 192.168.5.1 dev LinBPQTAB?
? ? ? ?(on se0yos)
in the IPGATEWAY config with the route command? ?
73,
?
Thomas
|
Mark Phillips