开云体育

Hello all, I suspect the 3 reports below were all citing the same issue that wss fixed by the release posted yesterday at https://www.cantab.net/users/john.wiseman/Downloads/Test/pilinbpq

Ok, thank you

BTEXT is only sent to ports with an UNPROTO address so won't be sent to your Port 3. 73, John

Ok, so off on another fine tuning adventure - As it deals with aprs, does btext and btinterval play into the config? PORT PORTNUM=3 ID=QtSM APRS TYPE=ASYNC PROTOCOL=KISS IPADDR=127.0.0.1 TCPPORT=8001

All's humming along very well now. Thanks for the help!

Hello All, It looks like the test release that was made available today via the link below has resolved this issue. https://www.cantab.net/users/ john.wiseman/Downloads/Test/ pilinbpq (

Will do, thanks for the feedback. DonP Sent from [Proton Mail](https://proton.me/mail/home) for iOS

Change to zero. 73, John

Hi John - just installed the new executable, that sorted things out for me.? Thanks! -- Charlie (N4NVD)

It's set to 1, John Sent with [Proton Mail](https://proton.me/mail/home) secure email.

Sorry, that fix wasn't quite right. Can you download again (same link)? Thanks, John

I'm not clear what you are saying. Is it your station call that always appears via tcp? If so, do you have BeacontoIS=0 in your BPQ APRS Config? If not, you are sending your beacon to the APRS-IS

So this is what LLM is suggesting me to do for my error, any recommendation from the group before going this route? The error log you're seeing indicates that *linbpq crashed with a segmentation fault

Yes, both are set the same. I've been testing for several days, but DW always comes through. When QtSM and BPQ are running, it will actually digi and send an rf beacon, it seems. Sent with [Proton

Given Direwolf is working, I would verify what path is configured in Direwolf and apply it to BPQ if it's different. Are both QtSM and DW configured to use the same method to key the radio? 73, Lee

Hi Mark, Once I switched from BPQ and QtSM to Direwolf stand-alone last evening, the RF path popped up again. So, other than your suggestions, BPQ is missing something. Who knows? I was using APRSPATH

I would change the APRSPath to that which is suggested by the docs. APRSPATH 3=APRS,WIDE1-1,WIDE2-1 ; Dest and zero to 8 digis I don't know where you got your ISFilter from, and I am no expert on

Yes, see the BPQ Log file. 73 - Dave - W7EES

Well John - this new executable crashes on connect to the BBS alias.? ran it twice to be sure then did a debug capture and put the whole mess into a new file (attached). -- Charlie (N4NVD)

Thanks John - just implemented the new executable, will test as soon as I finish attaching my bpq.cfg (renamed bpq32.sav so I can clear the passwords) -- Charlie (N4NVD)