开云体育

Put it above the CONFIG section of the port. -- 73, Mark, N5MDT Montgomery, Texas http://n5mdt.ham-radio-op.net:52852

pi@nc8q-bpq:~/linbpq $ ./linbpq G8BPQ AX25 Packet Switch System Version 6.0.24.69 March 2025 Copyright ? 2001-2025 John Wiseman G8BPQ Current Directory is /home/pi/linbpq Log Directory is

Yes, it is done all the time. Are you wanting to access you own node or someone else'? Are you wanting others to access your node to access mail from CMS or just you? -- 73, Mark, N5MDT Montgomery,

Had the same thing here, I worked with the users and found out he set his YAPP directory straight to the Downloads directory. I suggested he create a folder inside the downloads directory and point

Hi, John: Awesome! Thanks. 73, Chuck

Each port has a parameter SendtoM0LTEMap. This defaults to 1 but and be set to zero to stop reporting that port. SendtoM0LTEMap=0 73, John

Would like to have Winlink Express using RF (packet) access to bpq node as for just sending and receiving emails from CMS. Got WLExpress to connect to node fine but no messages are getting sent or

Is this a new feature of Winlink Express? I've never seen it before. 73, John

John, Inline attachments like pictures between the text are just unceremoniously dropped by the BBS and deleted. This also the case for the html code.? (Non-inline attachments are fine.)? Is this

John, I’ve noticed in the bbs log on incoming connections the port and frequency used are reported, but the CMS log does not. ?I’m curious to know by what mode my users are using when connected

Very likely, yes 73, John

Could you run addr2line -e linbpq 0x523e85 0x49fa71 0x49fb18 0x49fa36 That should give the source lines where the problem occurred. Thanks, John

A station connected via VARA HF and attempted to download a small text file using YAPP. The transfer aborted with "Unexpected message during YAPP Transfer." Would that happen if the person

Hello, I have just noticed that LinBPQ sometimes prematurely exits. (I am unsure whether it is an issue related to KAM driver I added recently.) See the initialization of all ports, and later what

OK, although the subject line is M0LTE MAP, and there is a reference to adding "EnableM0LTEMap=1" to bpq32.cfg, you were actually asking about the BPQ map at http://vps1.g8bpq.net/. That map is not

[email protected]> wrote: when it was shared earlier. Updated now. 73, Lee K5DAT

http://vps1.g8bpq.net/ -- 73, Mark, N5MDT Montgomery, Texas http://n5mdt.ham-radio-op.net:52852

[email protected]> wrote: Mark, Which node map has the modem mode tab? The one I had bookmarked was http://nodemap.g8bpq.net:81/, but I'm not seeing a tab there. Thanks, Lee K5DAT

I'll try this. Thanks Mark, Lee and Robin. Em ter., 22 de abr. de 2025, 09:51, Mark Taylor via groups.io <mtaylor= [email protected]> escreveu:

Great! Thanks, Robin. :-) Em ter., 22 de abr. de 2025, 09:49, M0JQQ - Robin via groups.io <m0jqq.robin@...> escreveu: