开云体育

No, that doesn't look right. Could you send me your config? What version of BPQ are you running? Thanks, John

Sorry meant to add this as well. Initialising Port 05 VARA Host 192.168.86.34 8351ELIMIT 5 Is this correct John?

Had to stop the auto start, appears that is setting the 5 min limit. I have it low while testing. Thanks all, we will see what happens.

It must be after CONFIG but not within a RIGCONTROL block. I've tried it here and it seems to be working. Do you get any error messages when you start BPQ? 73, John

Still not working..

Will try again, but I have had it set in all those locations with no joy.

Or move them up so that they are above the RIGCONTROL statement. Either way they have to be outside of the rig control section. 73, Lee K5DAT [email protected]> wrote:

Move both Session... and BW to after the ****

Looking for assistance with this command in my VARA HF port. I am finding the need to put a limit on this port, to counter the RMS users that think they should use VARA HF to download a week or two

Anyone running Clover on there bpq32 ?

Hello! Debian Security team are tracking it: https://lists.debian.org/debian-security-announce/2025/msg00061.html It has been fixed in Bookworm (12), Trixie (Testing/13) and Sid (Unstable) but **not

Thank you John.... then I will not try :) All the best and thank you from Alan G0WDA - Blackpool

In my view, no. 73, John

Hi John, Thank you for the information I have learnt a lot from you... Question: is there any value in interfacing my bpq1 to the 44 network please if yes? do you have a section I can look at

In the messages that I see the majority are using BPQ. If you look in the R: lines at the top of each message you should be able to see what software is being used by the station forwarding the

Hi John, Yes there is 693 messages so far :) Thank you.... It appears people are using FBB what is the reason for this, does it give the user a better experience ??? All the best from Alan

That seems to be working. Can't you see the messages on your BBS? LIS gives monitor output. The resolution of the image is too low to be able to sure but it seems to be showing similar info to the

Did you set it to monitor port 3 in the Monitor Menu? What does AXR 3 show? Have you seen https://www.cantab.net/users/john.wiseman/Documents/QtTermTCP.html 73, John

Hi John, This is from the bbs_logs

Hi John, I did a lis 3 in Qttermtcp and got this...