开云体育

Hi John, Missed half your question, if i use MH 5 which I dont have it comes up with Invalid Port All the best from Alan

Do other commands (eg ports) work? If you do MH with an invalid port do you get an error message? 73, John

Hi John, if what you are showing me is a header, then yes but that is all, I am operating in SIMPLE mode... All the best from Alan

Hi Chuck, yes you are my call sign is G0WDA on qrz, my website is g0wda.co.uk All the best from Alan

Hi Steve I presume this is a website, but for me it brings nothing up... All the best from Alan

Hi Steve, Port 1 is the 2m VHF Port, had a few people come in on that port But when you do MH 1 you get nothing not even a hearder All the best from Alan

I assume it returns a header but no entries, eg NOTTM:GB7NOT-2} Heard List for Port 1 Most likely either Port 1 is a Telnet Port or an RF/AXIP Port that hasn't actually heard anything. 73, John

Hi, Alan: Not required for [email protected], but helpful for my brain. I would like to assume I am communicating with an licensed Amateur Radio operator. :-| 73, Chuck

Alan What type of port is port 1? If AXUDP make sure there is MHEARD in the CONFIG section of that port in BPQ32.cfg Also, are you aware if the OARC discord and UK packet map? ESC is not

Good morning all. Matt KB8UVN has an allstar node called Ohio Packet Hub 510810. I have teamed up with him and connected my Allstar node and ADN DMR Network together. The TG on the ADN Network is

Hi Chuck, no problem, did not know you should have a callsign email for this group. All the best from? Alan

Oh, my, I thought you were my neighbor Alan in Ohio, USA. Your callsign is not in your email address. Silly me. Sorry. 73, Chuck

I presume you need this chuck MAP GB7ESC ESCBBS UDP 10093

Hi Chuck, Thank you for the reply, please remember I am new to all this my knowledge is minimal :) I have added MAP NC8Q nc8q-bpq UDP 10093 B What do you need from me :) All the best from Alan

Hi, alan: Dunno. Let's MAP our NODEs/BBSs so that I can issue a PORTS command on your NODE. You can add MAP NC8Q nc8q-bpq UDP 10093 B in the PORT ?ID=AXIP Link ?DRIVER=BPQAXIP section of your

Good Morning everyone, I using the command MH 1, but it returns nothing Is there a logging function I have missed All the best from Alan

Would be nice to have a connect you to Europe. Send me a PM and I send you my MAP 73 Erwin, OE1EKG

Hello Reinaldo,It would nice to have a partner in South America. Please send me your email address so I can send you my MAP info or I can post it here.Chris Lanceww2bsa@...

Hello! I'm in the process of finalizing my LiBPQ setup and I'm looking to connect with a couple of link partners. My map: MAP PU2XTC-4 PU2XTC.DDNS.NET UDP 10093 B 73's TKS! Reinaldo Oliveira