开云体育

Hey Glenn Yes, I had this happen yesterday after I downloaded .59 and started it up. It ran for 5 or 10 mins and then and then crash. I'm running pilinbpq on a RPI4b with Bullseye OS. I'm running

Hi Glenn, I do not use rPi's but .59 has been stable here on x64. I've had it running on 10m in the "lab" for about 2-3 days now. RF connects are only from me as I move around the house but include

This should have read:? You definately need a Digimap 3=3,IS And that is the only Digimap statement you need.? At least until you fully understand it. -- 73, Mark, N5MDT Montgomery, Texas

Upgraded Pilinbpq to 6.0.24.59 and after about 5 minutes BPQ closes down with the following message. SIGSEGV Received Went back to .45 which is working fine. Anyone else seeing this? -- -- *Apologies

Gee, I'm no expert but I periodically activate my digimap feature in order to assist others.? I have never seen a reason to 'connect' to telnet.? What exactly is being accomplished by this? AprsDigi

Hello Rory, In the attached version I did the following: - Removed the multi-line comment beginning markers that preceded ports 1 and 2 (changed them to comments) - Commented out your port 3 and

And probably DIGIMAP=2,3,IS I dont know if there is a point to digimap on telnet?

Actually i see it now. I must have got a downloaded incomplete config last time. I dunno, you might need to get that IOADDR to match the port in CONFIG. It has to be converted to HEX.

Rory, You are missing a port definition for the soundmodem. Add either an AGW port or a KISS port to the config for portnum=3. One of these would work most likely. KISS:

Hi all, I really tried the documentation and some examples out there.? By config file is attached. Curretnly expecting the APRS to connect to TELNET (it does).? And the radio. Radio - VHF FM via

I, too, would employ this if it was available.

Direwolf and AX25

Hi John, ???????? Thanks for your popular BBS system, may I propose you with a suggestions? On top of using tap that use the Linux stack, having the possibility to use TUN would be nice,

If it is a VARA or ARDOP session it uses HFCTEXT. What client software is being used? 73, John

I have a simple (no BBS, CHAT or APRS) Winlink Packet Gateway running on a Raspberry pi using linbjpq. Stations connect, receive and send WL email. Is there a way to have a welcome message displayed

Seems that it starts this issue around hamlib 4.5 after digging further.

Hi, I just wanted to post to folks who may experience lag with BPQ and rigctl(d).exe commands. It seems that there is something different in 4.6.1 that causes lag. Im not sure as I did not deep dive

I was thinking of your Port 4 as a packet port and not an APRS port.? It should first work with simple packets.? That is the reason I suggested removing the APRS call on the BCALL line, and the

I think it would be great to have: Enable Forwarding (Check) Send Type P/T messages after? _____ seconds. Send Type B messages after _____ seconds. And stop the polling with no good reason.... Start

So I have made the changes still same situation, I am focusing in Port 4 the APRS frequency of 144.390 for this initial test. Probably this next question are directed to John and/or the developers. Is