开云体育

And probably DIGIMAP=2,3,IS I dont know if there is a point to digimap on telnet?

Actually i see it now. I must have got a downloaded incomplete config last time. I dunno, you might need to get that IOADDR to match the port in CONFIG. It has to be converted to HEX.

Rory, You are missing a port definition for the soundmodem. Add either an AGW port or a KISS port to the config for portnum=3. One of these would work most likely. KISS:

Hi all, I really tried the documentation and some examples out there.? By config file is attached. Curretnly expecting the APRS to connect to TELNET (it does).? And the radio. Radio - VHF FM via

I, too, would employ this if it was available.

Direwolf and AX25

Hi John, ???????? Thanks for your popular BBS system, may I propose you with a suggestions? On top of using tap that use the Linux stack, having the possibility to use TUN would be nice,

If it is a VARA or ARDOP session it uses HFCTEXT. What client software is being used? 73, John

I have a simple (no BBS, CHAT or APRS) Winlink Packet Gateway running on a Raspberry pi using linbjpq. Stations connect, receive and send WL email. Is there a way to have a welcome message

Seems that it starts this issue around hamlib 4.5 after digging further.

Hi, I just wanted to post to folks who may experience lag with BPQ and rigctl(d).exe commands. It seems that there is something different in 4.6.1 that causes lag. Im not sure as I did not deep

I was thinking of your Port 4 as a packet port and not an APRS port.? It should first work with simple packets.? That is the reason I suggested removing the APRS call on the BCALL line, and the

I think it would be great to have: Enable Forwarding (Check) Send Type P/T messages after? _____ seconds. Send Type B messages after _____ seconds. And stop the polling with no good reason....

So I have made the changes still same situation, I am focusing in Port 4 the APRS frequency of 144.390 for this initial test. Probably this next question are directed to John and/or the

Rich, I took for granted that it would still be a two way communication if the internet was working, but your right that was not how I explained what was looking for.

Hi Glenn, Perhaps some additional detail on the issue or request might help. Your response says "looking to retrieve their messages from the CMS" but your initial ask was for "a way to configure BPQ

Thanks John, That works for inbound messages, but not for a station looking to retrieve their messages from the CMS.

Thanks Glenn, It seems like when an outgoing message is larger than what is specified via MSGTYPES, the BBS should not connect to the far end first before checking the size. Of course if there are

Thanks John. I was thinking in terms of a user-configurable timer, but what you describe below might do the trick and would also be less confusing for new users. 73, Lee [email protected]>

This is my config to send APRS beacons via VARA HF, the PTT in VARA is done via CAT from BPQ: ;--------------------------------------- ?HF 14.103 / 10.1482 PACKET PORT