开云体育

Hi everyone Sorry if this is a dim question, but with the IP config spoken about here ( /g/bpq32/message/42440 ) , would I be able to run BPQ as a packet switch but, if necessary,

Hi Jim, Also I have reached out to you via PM here. When you get it or not let me know either way. Happy to accommodate. You can email me at my mail on QRZ, if you have a path to me via packet or I

Jim, I sent you an email to your QRZ address even though I am a state further away than you requested. Did not receive a response.

Heber, The on-line help points to this page. http://www.w1hkj.com/ Also on Windows, the documentation for rigctl and all of the modules of Hamlib are in folder from the downloaded zip file. The

Now trying to ping the bbs from a pi5 bookworm 64bit... direwolf /? tncattach with setup for ip with 10.0.0.10/24 and bbs with 10.0.0.1/24. pi desktop pings out rf interface correctly,? no response

that was the last part of the puzzle...thx you for the help and everyone else too.? it's working

sudo setcap "CAP_NET_ADMIN=ep CAP_NET_RAW=ep CAP_NET_BIND_SERVICE=ep" linbpq I think you may be missing the above command from the linbpq documentation. The above assumes you have renamed the

Oh those 4 asterisks LOL, well that made a difference... now to the next issues :) I wiped the pi and started with bookworm 32bit lite....all went well. installed linbpq went well. all is working

When you comment out the IPGATEWAY statement it may render the others unrecognized, thus the error.? Use a multi-line comment when commenting out the IPGATEWAY section: /* IPGATEWAY Adapter

Good day. Here is the full configuration example on the BPQ website. Note there are 4 asterisks at the end to mark where the IPGateway feature ends. There are several BPQ features that use this

OK when I am enable IPGATEWAY linbpq will not run..... heres the config when I remark out the IPGATEWAY ;IPGATEWAY Adapter eth0 44ENCAP 100.64.1.223 IPAddr 10.0.0.1 IPNetmask 255.255.255.0 IPPorts

I think I understand what you are trying to do. Even if you are not using tunnels, etc. and only need to run IP over ax25 via a radio, you still need to run the "full fledged" IPGATEWAY feature. You

Hi Mark, its not in the port conf section...Linbpq on a pi4....

Thanks John, I can live with it for now, looking forward to the next version! TNX es 73

At the moment the only solution is to turn on "Don't check from call" in the main bbs config. The next version will include SERVIC as a valid from call. 73, John

Looking for link partners in adjacent states, NE, MO, AR, OK, already have CO and IA. my map, ?MAP KI0BK-7 KI0BK.NO-IP.COM UDP 10093 B I'm located in the Kansas City metro area in KS TNXes 73 jim

Sorry to drag this up again… I’m getting some msgs from SERVIC@... addressed to me KI0BK that are being held so are being delivered in a timely manner to me. ?I could not tell from the

Thanks, Rich. 73, John

Thanks John. I just had a chance to retest with the final .77 and can confirm this is fixed. 73 de Rich WA3WLH

I think I understand what you are trying to do. Even if you are not using tunnels, etc. and only need to run IP over ax25 via a radio, you still need to run the "full fledged" IPGATEWAY feature. You