开云体育

OK Mark.? I tripled checked all settings and got the same results as before.

Hold on.? I must not have saved my changes properly.? Let me try again.

My outgoing Winlink message didn't upload either.

BBS log after making your suggested changes: 240920 14:50:42 |AI7HH ? ? Incoming Connect from AI7HH on Port 5 Freq 0 Mode VARA FM WIDE 240920 14:50:42 >AI7HH ? ? [BPQ-6.0.24.1-B2FWIHJM$] 240920

Ok, your nodecall cannot be -1 because you are using that as your BBS call. Make NODECALL=AI7HH-7 Change this line: APPLICATION 1,*BBS,,AI7HH-1,,, To this: ?APPLICATION 1,BBS,,AI7HH-1,AIHBBS,255 In

Thanks Mark. NODECALL=AI7HH-1 Test station call sign is AI7HH Verified that VaraFM Command Port in the Vara TNC is 8400 and Vara HF is 8300. 73 Dan - AI7HH

Your node call, and the call you are using in Winlink Express are also pertinate. What are they? And you can use VARAFM as the drive. I think they will both work though. I assume that you have set the

Apologies in advance if this turns out to be a stupid question with a simple answer (which I suspect will be the case.) I'm trying to add a VaraFM port to my node and have been testing by connecting

Yes, same as with VARA HF 73, John

With a Vara FM port in BPQ, is it necessary to ATTACH to the port as part of the connect script for forwarding? It's been a while since I had a Vara FM port and just don't remember...

What is your client? Looking at the BPQ Node map it appears that you have your NODECALL set to both K4SPB and K4SPB-7 at one time. But I see you are offline at the moment. Your config does not assign

If I connect to K4SPB-1, client and server send packets back and forth every three to five seconds then disconnect less than a minute after connection. It does this with all of the ssids.

Today the error is showing when I have listen -at running. Usually its in the terminal of whatever client program I'm using. Below is the output of listen -at and the output of? easyterm I did adjust

You are using TCPPORT 8100 for channel B and 8001 for channel A.? Is that an error?? Usually it would be the same TCPPORT to a single device and the Channel separates the data to each port.

Where are you seeing the error message? 73, John

VARA Terminal uses the same protocol as VarAC which will not operate with AX25. Use QTtermtcp from the BPQ downloads page. QTtermtcp will use VARA among others that will allow you to connect to packet

I'm getting the above error when attempting to test my node. I've recently tried a fresh cfg from the config generator after days of tinkering with my old cfg. Setup is a pi4 with a DRAWS board to an

Mark For some reason it didn’t like port 6 so i changed it to 4 and it works Robby

I did the att 6 but it never attached the port

Robby, my initial thought is that you will have to attach the port first, then issue a connect. If it is an RMS you are connecting to you should be able to connect, if it works, but you woul dhave to