开云体育

You are using TCPPORT 8100 for channel B and 8001 for channel A.? Is that an error?? Usually it would be the same TCPPORT to a single device and the Channel separates the data to each port.

Where are you seeing the error message? 73, John

VARA Terminal uses the same protocol as VarAC which will not operate with AX25. Use QTtermtcp from the BPQ downloads page. QTtermtcp will use VARA among others that will allow you to connect to packet

I'm getting the above error when attempting to test my node. I've recently tried a fresh cfg from the config generator after days of tinkering with my old cfg. Setup is a pi4 with a DRAWS board to an

Mark For some reason it didn’t like port 6 so i changed it to 4 and it works Robby

I did the att 6 but it never attached the port

Robby, my initial thought is that you will have to attach the port first, then issue a connect. If it is an RMS you are connecting to you should be able to connect, if it works, but you woul dhave to

Have anyone attempted to use Terminal to connect to another station on VARAFM I get a message that says this is not and axip port any suggestions. AA5AF

I have a Linbpq node up and running with just packet. Internet is coming and I will be enabling an RMS. The next step is to add an HF port, probably VARA. I have successfully been running VARA from

Hi Angelo,?I think you can find THENET here:https://www.theskywaves.net/thenet.htmlEnjoy.73 de Chrisww2bsa.org

It should look for it in the directory you're starting in. See you running a script instead of starting pilinbpq directly? 73 Steve [email protected]> wrote:

Let me know if you cannot find it as well as which version.. I recommend ThjeNET 2,08b I believe is what I always use.. Ill dig out that version and have it on hand.. May have to fire up my old WiNXP

I would like to thank for the replies. I am looking to use an old MFJ-1270B. I will look to see if I can find the THENET code somewhere. I will being burning the rom myself. Again, Thanks all for the

Hi All Done something stupid and now cannot start PiLinBPQ, keep getting error code 2. Reading it a little more carefully I see that BPQ is in directory "home/gb7sou/Ham/pilinbpq" but BPQ is looking

Very helpful information guys thanks for the review. We are still running standalone Bpq in Gainesville, Florida. Gordon kx4z

NET/ROM and TheNET were very similar. Both run in an EPROM in a Z80 TNC-2 made by TAPR or licensed from TAPR. Companies that made these include AEA, PacComm, MFJ, DRSI, maybe others. The EPROM was a

It depends on what you are asking for. Do you want to set up a TNC to run a node? If THIS is what you want, you need to know that "NETROM" was software loaded into a ROM that could be plugged into a

If you are referring to netrom in Linux, the info available via this link might be helpful. https://www.elite.uk.com/mike/posts/linux-netrom-setup/ 73, Lee K5DAT [email protected]> wrote:

The original NETROM was an eprom for the TNC2 that was sold by Software 2000 ( if I remember correctly). As far as I know it is no longer available. TheNet was an (allegedly illegal) copy. Not sure if

NetRom is a routing protocol that is part of all the different bbs software packages. -- Charles J. Hargrove - N2NOV NYC-ARECS/RACES Citywide Radio Officer/Skywarn Coord. NYC-ARECS/RACES Nets