开云体育

Hello, I am trying to set up a node that can run an application for me that can be accessed via hf radio. I have a test setup with two each of hf radios and sound cards and computers (the server

Were you ever able to get this working? I just went through the process of setting up LinBPQ and was hoping I would be able to send and receive messages on it through RadioMail!

Hi Kevin. QtTermTCP monitor is probably the simplest and if you have a recent version you can log monitor output to disk. Assuming it is a single netrom connect then any packet resequencing will be

Hello John I run a BPQ node in the South West of England and have observed some occasions where packets are arriving out of order over NETROM. The symptom is seen when connecting over 2 hops (so 3

Jeff to the rescue!! - Thanks! 73 de Chris ww2bsa

Keep forwarding enabled and tick Send Personal Mail Only.? That'll work; I found out by accident a couple years ago... Personal Mail Only was ticked and I didn't know it, and wondered why Bulls were

My forwarding partner is requesting a temp stop to sending bulletins to his BBS. Should I: Un-tick? Enable Forwarding? (or will this stop ALL forwarding - personal and bulls?) Tick Send Personal

John: It was a case of bad syntax.? We had set it to: AUTOADDMAP OFF BPQ32 ignores the argument and enabled it. Correct syntax: AUTOADDMAP ...by itself with no arguments, and a semicolon to

A means automatically added as a result of AUTOADDMAP. If you don't have that then it looks like a bug. Can you send me the config? Thanks, John

For the time being, we locked out the route in the "ROUTES:" table. I found the answer to the "A" question in a previous topic. 73 - Rick KE0GB

In addition:? AUTOADDMAP is not enabled at N0HI-7. RH

John: We have a question regarding the axresolver: What does an "A" at the end of an axr <port#> line mean? e.g., appearing on N0HI-7 node: AC0VC-7 = 74.81.169.118 10093 = 74.81.169.118 B A We

Thanks, John. :-) 73 Em sex., 9 de ago. de 2024 12:34, John G8BPQ via groups.io <john.wiseman= [email protected]> escreveu:

Try ?PORT SPEED YAESU FT1000MP 73, John

Thanks, Mauro. 73 Em qui., 8 de ago. de 2024 13:12, Mauro - AG7BI via groups.io <ag7bi= [email protected]> escreveu:

The CI-V is for ICOM radios not Yaesu. For Yaesu you just need just the serial port. I don't have that model so I cannot be more specific.

Hi folks. I have an FT-1000MP with a CAT control cable, but I can't create a RIGCONTROL, don't work. I suspect it is the CI-V address. What would be the value? Does anyone know the correct line for

Thanks, Mauro. I'll look into it. 73, John

John - G8BPQ, using QSoundModem 72 and BPQ 6.0.24.40 in Linux restarting the node causes a segfault of the modem. I am not sure if this is a problem with my system or a bug since I just moved? from

This reply seems to be off topic. 73, Chuck