开云体育

Click on the link and scroll down to APRS2 Group, Addresses for APRS2 severs is on the left. 74 Ken G7VJA ex MB7UFO Igate. (22years)

Re Ken's comments- not sure what to use but this defines the servers that exist- http://www.aprs-is.net/APRSServers.aspx

I found the problem- my ISP is apparently blocking things. (like, a LOT of things apparently). After I did the connect tests it dawned on my I was running a VPN on the PC so I turned it off and could

Hi John Looking at the result on the message the ip address is wrong it should be rotate.aprs2.net:14580 not aprs.net root@kenny-XC-215:/home/kenny# telnet rotate.aprs2.net 14580 Trying

Something on the pi must be blocking the connection, as you can connect from the same lan on a pc. Can you connect to other things on the Internet from the pi? eg telnet nottm.g8bpq.net 8011 73, John

Aha, there is certainly a network issue here. Lets see output of: traceroute rotate

NODEFAULTROUTE configured in IPGATEWAY section- no cfg errors on start- still no connect to APRS server. TELNET RESULTS FOR JOHN: APRS server connect via telnet result on Pi: root@Pi-BPQ:/home/pi#

Then configure it, is what I meant :-)

Can you try this from the Linux command line? telnet rotate.aprs.net 14580 I get this: Trying 192.104.234.220... Connected to rotate.aprs.net. Escape character is '^]'. # aprsc 2.1.14-g5e22b37 You may

Hi All mine is written in Upper & lowercase IGATE Params. ISHost= ISPort= ISPasscode= ISFilter= 73 Ken G7VJA GB7COW

Noticed ports defined in IPGATEWAY were 1 and 2 so I added 3 (APRS port) but still getting error. I then removed it since error persists. Port Driver ID Beacons Driver Window 1 BPQAXIP (

Also I noticed in my IPGATEWAY cfg there were references to old local ip addresses. I corrected those (44ENCAP and TAP lines specifically) and only change I see is that an? "APRS Igate connect

Thank you. "NODEFAULTROUTE" is not configured. The ENDPORT error was just a missed line that needed to be commented out from an unused port. Error cleared there. igate not connecting continues.

*bpq32.cfg line no 225 not recognised - Ignored: ENDPORT Heads up ^ *

This is just a hunch. The APRS connection may be trying to go out of the TAP device instead of your regular network. Make sure there is not a default route for non-AMPR traffic pointing to the TAP

Just tried the server you suggested. "ISHOST=noam.aprs2.net" Same error. Thank for the suggestion.

git clone git://vps1.g8bpq.net/QtSM should give you 0.0.0.63 (the latest) 73, John

This message is probably for John but if anyone can answer it would be great. I am experiencing a number of different versions of QTSoundmodem. The one in the source zip file seems to compile to

Hi All, Cheers for that, a silly misconfig by myself :) - I hope to be back in shack this evening to try it out. I set it to PMS to indicate there's no routing or anything going on i.e. You can only

Hi Red & Mike If Mat is running RF as well on his BPQ PMS, he can only run it unattended for 30 minutes maximum, after that he has to turn it off, (terms of his licence) because it is using RF. just