开云体育

hI kk6qms I forgot to answer your GUI question GUI means Graphical User Interface, means you have Icons or a tab to start a program Non GUI means you start a program via a terminal command line

In it hey day it was frowned on the use the core servers, hence the T2 server network was setup, I ran T2ENGLAND which got it's feed from one of the core server, if mine lost the link it was switched

Yes that is easy to see- but why use tier 2 vs core servers? I'm not clear on what is a GUI vs non-GUI client as referenced (core servers seem to work fine in my cfg currently). Thx. " *Core Servers

Click on the link and scroll down to APRS2 Group, Addresses for APRS2 severs is on the left. 74 Ken G7VJA ex MB7UFO Igate. (22years)

Re Ken's comments- not sure what to use but this defines the servers that exist- http://www.aprs-is.net/APRSServers.aspx

I found the problem- my ISP is apparently blocking things. (like, a LOT of things apparently). After I did the connect tests it dawned on my I was running a VPN on the PC so I turned it off and could

Hi John Looking at the result on the message the ip address is wrong it should be rotate.aprs2.net:14580 not aprs.net root@kenny-XC-215:/home/kenny# telnet rotate.aprs2.net 14580 Trying

Something on the pi must be blocking the connection, as you can connect from the same lan on a pc. Can you connect to other things on the Internet from the pi? eg telnet nottm.g8bpq.net 8011 73, John

Aha, there is certainly a network issue here. Lets see output of: traceroute rotate

NODEFAULTROUTE configured in IPGATEWAY section- no cfg errors on start- still no connect to APRS server. TELNET RESULTS FOR JOHN: APRS server connect via telnet result on Pi: root@Pi-BPQ:/home/pi#

Then configure it, is what I meant :-)

Can you try this from the Linux command line? telnet rotate.aprs.net 14580 I get this: Trying 192.104.234.220... Connected to rotate.aprs.net. Escape character is '^]'. # aprsc 2.1.14-g5e22b37 You may

Hi All mine is written in Upper & lowercase IGATE Params. ISHost= ISPort= ISPasscode= ISFilter= 73 Ken G7VJA GB7COW

Noticed ports defined in IPGATEWAY were 1 and 2 so I added 3 (APRS port) but still getting error. I then removed it since error persists. Port Driver ID Beacons Driver Window 1 BPQAXIP (

Also I noticed in my IPGATEWAY cfg there were references to old local ip addresses. I corrected those (44ENCAP and TAP lines specifically) and only change I see is that an? "APRS Igate connect

Thank you. "NODEFAULTROUTE" is not configured. The ENDPORT error was just a missed line that needed to be commented out from an unused port. Error cleared there. igate not connecting continues.

*bpq32.cfg line no 225 not recognised - Ignored: ENDPORT Heads up ^ *

This is just a hunch. The APRS connection may be trying to go out of the TAP device instead of your regular network. Make sure there is not a default route for non-AMPR traffic pointing to the TAP

Just tried the server you suggested. "ISHOST=noam.aprs2.net" Same error. Thank for the suggestion.

git clone git://vps1.g8bpq.net/QtSM should give you 0.0.0.63 (the latest) 73, John