开云体育

Hi John, I don't know or this is possible with WinLink Express, I have it but don't using it often as I normally use Linux with Thunderbird. 73, Boudewijn VE3TOK use Thunderbird -- There is

It sounds like you have already applied for and were approved to be a Winlink Gateway, is that the case? Have you followed the documentation about this to create a user called RMS and set the

Yes Mark, I just want to rf into my own bp32 node (at home,) in the local area from my mobile setup using Winlink Express packet just for my personal use. The node works now with my mobile setup using

I can't see how to add an inline image to a winlink message. How are you doing it? Thanks, John

Hi, Mark: Thanks. Now: pi@nc8q-bpq:~/linbpq $ head? bpq32.cfg EnableM0LTEMap=1;? goes in the global section, above all ports. ;

On 4/21/25 11:10, Simon G4WQG via groups.io wrote: I added my offset so folks can determine my center frequency. NC8Q-7 LINBPQ 6.0.24.69 * AX.25 port 6 (7.1015MHz 300bd AFSK) - +800Hz QtSM_A

Source record not recognised - Ignored:EnableM0LTEMap=0 The PORT param is SendtoM0LTEMap=0 It goes in the main section of the PORT config, before CONFIG EnableM0LTEMap is a global command and has

Great! Thanks Chris. Em qua., 23 de abr. de 2025, 10:21, Chris Lance WW2BSA via groups.io <Ww2bsa@...> escreveu:

Hello Mauro, Although most have already suggested many maps, here is one more resource that you might find enjoyable: Nationwide Amateur Radio Packet Directory Map

Correction.... EnableM0LTEMap=1? goes in the global section, above all ports. SendToM0LTEMap=0? goes in a port, above the CONFIG section to prevent just that port from being reported. To not

Put it above the CONFIG section of the port. -- 73, Mark, N5MDT Montgomery, Texas http://n5mdt.ham-radio-op.net:52852

pi@nc8q-bpq:~/linbpq $ ./linbpq G8BPQ AX25 Packet Switch System Version 6.0.24.69 March 2025 Copyright ? 2001-2025 John Wiseman G8BPQ Current Directory is /home/pi/linbpq Log Directory is

Yes, it is done all the time. Are you wanting to access you own node or someone else'? Are you wanting others to access your node to access mail from CMS or just you? -- 73, Mark, N5MDT Montgomery,

Had the same thing here, I worked with the users and found out he set his YAPP directory straight to the Downloads directory. I suggested he create a folder inside the downloads directory and point

Hi, John: Awesome! Thanks. 73, Chuck

Each port has a parameter SendtoM0LTEMap. This defaults to 1 but and be set to zero to stop reporting that port. SendtoM0LTEMap=0 73, John

Would like to have Winlink Express using RF (packet) access to bpq node as for just sending and receiving emails from CMS. Got WLExpress to connect to node fine but no messages are getting sent or

Is this a new feature of Winlink Express? I've never seen it before. 73, John

John, Inline attachments like pictures between the text are just unceremoniously dropped by the BBS and deleted. This also the case for the html code.? (Non-inline attachments are fine.)? Is this

John, I’ve noticed in the bbs log on incoming connections the port and frequency used are reported, but the CMS log does not. ?I’m curious to know by what mode my users are using when connected