开云体育

Are you talking about the maps at http://guardian.no-ip.org:81/ and vps1.g8bpq.net? If so, you don't configure anything. Your call will be red and will appear on the Heard map if you hear packets on a

I tried adding info to the MAPCOMMENT parameter and adding the UPDATEMAP parameter, with no change to the map listing….. would help to know what the map keys on to make the decision if the node is

I need the actual file, not a listing of it. Thanks, John

Thanks guys. Back up and running normally. -Chris KQ6UP <kilo5dat@...> wrote: -- Thanks, Chris Maness

shure, here it is, only ASCII. Host is a Linux Mint, aktual patchlevel. SIMPLE LOCATOR=JN59NG NODECALL=DO1ATM-10 NODEALIAS=RHBBS CTEXT: Willkommen in der RHBBS von DO1ATM (ein Linpbq Node) ____ _ _

Ok NO KISSHF does not report, which explains why my WinRPR is not showing.

Aye, It is not explicitly put in the various modem drivers. I have found it by some trial and error. But it IS listed in the uz7ho driver:

I don’t see Frequency and Updatemap in the documentation but i am pretty new to bpq so i may not be looking in the right place…. I will put an “UPDATEMAP” in my config and see what

Mark et alia: Used after PORT ... ?CONFIG ? I have ";FREQUENCY..." 3 times in my bpq32.cfg file. Obviously I have had issue this NAME|VALUE pair. Is this an information line or does it attempt to

I *think* you need the UPDATEMAP in the port config. Tho it may not work for some ports types. I dont have a frequency line here, but have the RADIO section configured for rigcontrol. ``` PORT

Could you send me your bpq32.cfg file so I can see exactly what character's you are using? Thanks, John

ok, but everything is done in 'terminal'. The Config File is written in NANO, the BBS runs in a Terminal, the BBS Output is in Terminal, so everything should be the same I guess. I must confess, I'm

Ok thanks, much appreciated Bob

<christopher.maness@...> wrote: https://www.cantab.net/users/john.wiseman/Downloads/Beta/

Where do I find those executables? Thanks, Chris Maness -Sent from my iPhone [email protected]> wrote:

Probably all it will require is a FREQUENCY line.? Most likely you have anything else you need already. -- 73, Mark, N5MDT Montgomery, Texas http://n5mdt.ham-radio-op.net:52852

Always, always, always install the latest bpq32.dll, BPQMail.exe, and BPQChat.exe all at the same time.?? Ocasionally one will be the same version as the prior but it's better to get in the habit of

Hi my settings in the config file report my node to the bpq map just fine, but i am wondering what i need to do to the config to get it to report that it has an hf port too? -- Bob va3rjs

I installed the latest installer and then installed the latest DLL. My web interface for the mail (BBS) went away. I reinstalled again and I am back to normal, but running the 6.0.24.1 version. I

Pretty sure that refers to pure ASCII vs unicode. Jim KA7EHK