开云体育

;-) Hello George Kirn had contact with this data. [email protected]> wrote:

Just noticed this in your config... You should probably not have that line like that... make it this... BBS=1 NODE=1

Actually, you can.? Using WebMail you can address a personal message to AI7HH.? It will be on your BBS.? You should then be able to retrieve the message from Winlink Express. Note that your user

So, I was expecting the message you created in Winlink Express would be transmitted and stored in your BBS. In this configuration I don't think there is a way to send a message from your BBS to your

I should also tell you that although you are using Winlink Express as a client your message, if addressed like advised, will be in your BBS and will never be sent to the Winlink CMS.? That is a whold

I probably wasn't clear, but there is no change in the BBS log file since before I made the changes.? From what I can see, there has been no progress.? The BBS has always offered messages but the

Well, I see major progress in the log file.? It did connect, it checked for messages, then disconnected.? That's progress. Are you sure the message you created in Winlink Express was addressed to

OK Mark.? I tripled checked all settings and got the same results as before.

Hold on.? I must not have saved my changes properly.? Let me try again.

My outgoing Winlink message didn't upload either.

BBS log after making your suggested changes: 240920 14:50:42 |AI7HH ? ? Incoming Connect from AI7HH on Port 5 Freq 0 Mode VARA FM WIDE 240920 14:50:42 >AI7HH ? ? [BPQ-6.0.24.1-B2FWIHJM$] 240920

Ok, your nodecall cannot be -1 because you are using that as your BBS call. Make NODECALL=AI7HH-7 Change this line: APPLICATION 1,*BBS,,AI7HH-1,,, To this: ?APPLICATION 1,BBS,,AI7HH-1,AIHBBS,255 In

Thanks Mark. NODECALL=AI7HH-1 Test station call sign is AI7HH Verified that VaraFM Command Port in the Vara TNC is 8400 and Vara HF is 8300. 73 Dan - AI7HH

Your node call, and the call you are using in Winlink Express are also pertinate. What are they? And you can use VARAFM as the drive. I think they will both work though. I assume that you have set the

Apologies in advance if this turns out to be a stupid question with a simple answer (which I suspect will be the case.) I'm trying to add a VaraFM port to my node and have been testing by connecting

Yes, same as with VARA HF 73, John

With a Vara FM port in BPQ, is it necessary to ATTACH to the port as part of the connect script for forwarding? It's been a while since I had a Vara FM port and just don't remember...

What is your client? Looking at the BPQ Node map it appears that you have your NODECALL set to both K4SPB and K4SPB-7 at one time. But I see you are offline at the moment. Your config does not assign

If I connect to K4SPB-1, client and server send packets back and forth every three to five seconds then disconnect less than a minute after connection. It does this with all of the ssids.

Today the error is showing when I have listen -at running. Usually its in the terminal of whatever client program I'm using. Below is the output of listen -at and the output of? easyterm I did adjust