开云体育

Hi, Trying to configure ax.25 tcp on rf port...No tunnels,? no access past Linbpq and rf ports. I have went over and over what John has out as an example but Linbpq crashes when I Enable IPGATEWAY..

https://www.cantab.net/users/john.wiseman/Documents/RigControl.html

Where can I find the documentation of all RIGCONTROL commands? Thanks Heber - NP4JN

TU that was the missing piece! 73

Bleh, I did not format that. Let me try again. :D ``` ATT 3 HFPACKET C CALLSIGN ```

Jim, I *think* for that modem it is similar to this: For a normal (300 Baud HF Packet) call enter: ATT 3 HFPACKET C CALLSIGN If you want to, and have configured, you can send after ATT(aching) the

Can't figure this one out, I want to connect to another station using HF packet ax.25, not robust packet, using my SCS PTC-IIusb. I'm currently scanning for Pactor connects, so I need to halt scanning

Odd, I have that set in housekeeping so not sure if thats working. Say will it look at dates in the RLINES and determine it should be cleaned with housekeeping? KH I've used in a pinch. That works ok,

Housekeeping will remove messages older that the limits you've specified in the housekeeping config. You can also kill all held messages with KH. 73, John

Hi, Every once in a while someone makes a mistake and restores an old bulletin (or some other behavior that gives this appearance) and goes out to the network. Instead of getting them held, is there

Sorry, I thought I'd fixed that. I'll look into it. 73, John

Thanks, Rich. Em seg., 28 de out. de 2024, 18:12, Rich Sahlender via groups.io <wa3wlh= [email protected]> escreveu:

A segfault occurs in QtTermTCP on both 32bit and 64bit x86 systems while attempting a K2K session between two instances of QtTermTCP without any node software in between, with QTT configured for the

I'm seeing the same thing when using a Dragon and connecting with Winlink, completely separate from BPQ.? I believe it is a Dragon thing, not a BPQ thing.

I’m seeing this in the log sometimes as well, I’m using a PTC IIusb. Connections to the bbs are normal and working ok as far as I can tell.

Found the missing setting! added setting mycall to the config section of the pactor port. this parameter sets the modem's callsign to use on outgoing connects! PORT X .... Config .... MYcall KI0BK

I'm glad you've found the problem but it shouldn't segfault so I'll look at that. 73, John

Ok, found the problem..... I had a forward script where a couple of lines started with a # Something like this... #att 1 #c gb7iow #bbs This gives a seg fault... If you have something like this...

Can you look in the BBS log and see if it has recorded the call of the bbs it is trying to connect to. The segfault may have disrupted the logging, but if not disable forwarding the the bbs it was

So I have good news, *IT'S WORKING!* Adding the command RIGCONTROL the option of *DATAPTT* that I found used for radios with internal sound card like the Yaesu FT-991A did the trick! This is the