开云体育

What Steve said.? Add a TXDELAY=500 line to both nodes' ports to start with and if that works, reduce the TXDELAY till it's shorter but still long enough to work.? Also, disable your

This looks like it might be a DW connected mode issue, which it does not do well at all! The trace shows it sends multiple RR frames with no reply and then discs. The -1 mode does hear - 7 Does it

Hello, I am trying to set up a node that can run an application for me that can be accessed via hf radio. I have a test setup with two each of hf radios and sound cards and computers (the server

Were you ever able to get this working? I just went through the process of setting up LinBPQ and was hoping I would be able to send and receive messages on it through RadioMail!

Hi Kevin. QtTermTCP monitor is probably the simplest and if you have a recent version you can log monitor output to disk. Assuming it is a single netrom connect then any packet resequencing will be

Hello John I run a BPQ node in the South West of England and have observed some occasions where packets are arriving out of order over NETROM. The symptom is seen when connecting over 2 hops (so 3

Jeff to the rescue!! - Thanks! 73 de Chris ww2bsa

Keep forwarding enabled and tick Send Personal Mail Only.? That'll work; I found out by accident a couple years ago... Personal Mail Only was ticked and I didn't know it, and wondered why Bulls were

My forwarding partner is requesting a temp stop to sending bulletins to his BBS. Should I: Un-tick? Enable Forwarding? (or will this stop ALL forwarding - personal and bulls?) Tick Send Personal

John: It was a case of bad syntax.? We had set it to: AUTOADDMAP OFF BPQ32 ignores the argument and enabled it. Correct syntax: AUTOADDMAP ...by itself with no arguments, and a semicolon to

A means automatically added as a result of AUTOADDMAP. If you don't have that then it looks like a bug. Can you send me the config? Thanks, John

For the time being, we locked out the route in the "ROUTES:" table. I found the answer to the "A" question in a previous topic. 73 - Rick KE0GB

In addition:? AUTOADDMAP is not enabled at N0HI-7. RH

John: We have a question regarding the axresolver: What does an "A" at the end of an axr <port#> line mean? e.g., appearing on N0HI-7 node: AC0VC-7 = 74.81.169.118 10093 = 74.81.169.118 B A We

Thanks, John. :-) 73 Em sex., 9 de ago. de 2024 12:34, John G8BPQ via groups.io <john.wiseman= [email protected]> escreveu:

Try ?PORT SPEED YAESU FT1000MP 73, John

Thanks, Mauro. 73 Em qui., 8 de ago. de 2024 13:12, Mauro - AG7BI via groups.io <ag7bi= [email protected]> escreveu:

The CI-V is for ICOM radios not Yaesu. For Yaesu you just need just the serial port. I don't have that model so I cannot be more specific.

Hi folks. I have an FT-1000MP with a CAT control cable, but I can't create a RIGCONTROL, don't work. I suspect it is the CI-V address. What would be the value? Does anyone know the correct line for

Thanks, Mauro. I'll look into it. 73, John