开云体育

Thanks John...

No, it is now vps1.g8bpq.net 73, John

I am away and not on my usual computer, and having trouble opening the nodemap.? Can someone confirm the URL please? Is it still http://server2.g8bpq.net:8181/ That link shows only G8BPQ-9 Mark

The not very well named "Chat Terminal Mode" option in QtTerm enables keepalives. 73 John

Hello all, The issue I am having is when I am on a LTE hotspot QtTerm does not seem to send any traffic to keep the connection alive though the CG-nat and it dies after just a short time being idle.

Edit: However, when I use the UZ7HO Driver, CTEXT it starts to be displayed on all connections on the port, which causes delay and inconvenience in the RMS and BBS connection. Em ter., 25 de jun. de

I notice that CTEXT behaves differently when I use a KISS port or the UZ7HO Driver for Packet. With KISS CTEXT is only displayed when the user connects via NODECALL or NODEALIAS, and is not displayed

Thanks, John. 73 Em dom., 23 de jun. de 2024, 14:56, John G8BPQ via groups.io <john.wiseman= [email protected]> escreveu:

No, but you can from the Node command handler. APRS SEND CALL Message. 73, John

Hi folks. Is possible a user to send a APRS Message from BBS prompt? TIA

Aha, Thanks Mark! Yea I had overlooked that one and that seemed to do it.

If I understand your question, it is documented as part of the sample APRSDIGI config... ; You can specify a filter command to be sent when you log on to APRS-IS. Normally you don't ; need one. The

Hi, Is there some undocumented method to increase the range of stations noticed by BPQ's APRS maps page that I missed in documentation somewhere or on this forum? I am in a pretty low population area

If I remember right (pardon this Old Fart's Memory) BBS=0 and The BBSCALL and the BBSALIAS Should be the same as the NODECALL and NODEALIAS. Or something like that. - Randy, WR0RR.

I don't know if the linux versions use it, but also look for a BBS=1 configuration, and set it to BBS=0.? I don't remember is SIMPLE sets this or not but would imagine setting BBS=0 would take care

Remove the BBS and Chat application lines and the LINMAIL and LINCHAT lines from bpq32.cfg. You could remove the bbs and chat config files, but I'd just leave them in case I decided to use them in the

Effective immediately, the BBS and node LU9DCE will exclusively use IPv6. Please connect using the following address: *lu9dce.dynu.com* *Port 10093* Thank you for your understanding and cooperation.

Something must be going wrong here, If you remove a AXIP MAP record (and so long as you don't have AUTOADDMAP set) you will not be able to send or receive NETROM packets to/from that station over that

Good Evening Mark, Good to hear from you on here! I did try completely purging all records (User, NetRom, etc.) which I forgot to mention in the post. They kept repopulating though especially the

Thanks for the sysop command!