I am a total newbie learning his lathe.
I found out from this group previously that the quick change to hold her that I would need for my atlas 10 inch Lathe would be an AXA 250–111. If I am remembering correctly I was given a link and found it on eBay.
?
Question 1:? I went to eBay and found various options and makers.? Should I be concerned about the unit I buy being Bostar or Labworks, etc.?
?
Question 2:? Knurling tool - two types - which would you recommend??
I see two options within the Bostar brand:
A.? a Bostar unit selling an 11 piece set where the knurling tool is a a 250-110 that has the knurling integrated on one end and says the unit, "Can also turn with bits up to 1/2."??
?
B.? Bostar has a 10 piece set with its knurling attachment being a separate unit that fits into a 250-101:
?
Merry Christmas!
Lbrewer42