Re: Atlas / Craftsman 10F-12 10" & 12" Lathe Half Nuts / Split Nut
|
I installed brass half nuts on my lathe and fund if the leading edge that contacts the lead screw is increased they will close easier, I think that is because of the wear on the screw. If you close the new nut with out running the lathe then turn it on and run it back and forth that will help
GP
On Thursday, February 7, 2019, 5:59:00 PM EST, Rexarino <rexarino@...> wrote:
On Thu, Feb 7, 2019 at 11:44 AM seb fontana via Groups.Io <speedoo51=[email protected]> wrote:
The scribe marks on the wheel do not line up with the housing mark?
|
