开云体育

Randy Smidt has a new email. I just now caught that you had posted the old one. Please contact Randy at rsmidt1@... mailto:rsmidt1@....

Hi Dan, I'm down in NC, so that show would be bit of a haul for me. But you should contact the DC Z-Bend Track club. They are a Z-Bend modular group. Get ahold of Randy Smidt, [

Nice looking layout. Enjoy! Aaron D. Poscovsky 7510 HORNWOOD? Dr 1405 Houston, Texas 77036 281-455-0050 On Wed, Oct 25, 2023 at 4:00 PM, Malcolm Cleaveland<mcleavel@...> wrote: Attached

Attached are photos of a very portable Z scale layout that I take to train shows. It allows me to run 2 trains continuously. It was put together with some old Marklin track and turnouts I had. It

I am a member of the RMR and was wondering if there is interest in setting up a small Z-scale layout at our December 9-10, 2023 model train show at the Eagles Lodge in Fredericksburg, VA? Recently I

The Norway Zmod group has many modules that are somewhat compatible with the ZBT, although just 1/2 deep (front to back). The 2 tracks are same along the front and another of the module could be

Hello from Finland I have build two Standard Z-Bend-track modules withs has been on exebition in Finland last Autum. Now i build next module it will be Z-BandTrack standard Precentation module in

http://www.proto87.com/media/Z-scale-6-frog-800.jpg A long time I ago made a range of "Z" track parts, (see above) but the only activity I had was from larger scale narrow gaugers. Andy

Many are on Trainboard. Where are you located? I can try to put you in touch with somebody close by. -- John Duino jduino@... ----- On Feb 6, 2020, at 3:34 PM, John Partridge via

This forum is the Yahoo forum migrated over to groups.io. Yes, very little activity... You might contact the club closest to you for their techniques. Greg

Since there haven't been any posts to this forum for a couple of years, has everyone migrated to some other forum?? Modular Z-scale layouts still seem to be present at the National train shows, but

I can help. When I first read the document, I found some minor inconsistencies in the original specs that should be cleaned up. Additionally I posted a .pdf of the the end plate that could be

Niles depot! (Hope this post) Don

I'm here. I have experience of track and track standards. Plus I make the handaid track parts for Z. Andy Reichert

It has been a long time since this forum has been used. I am seeing who is still out there. I have been recently working on the Z-Bend standards, especially with the use of sectional track. I think it

Hi Larry, I just started a subscription to Railroad Model Craftsman and received the first issue a week ago. I will be looking forward to seeing the magazines as I bought many used copies of

David I received you check today but to late to get the package to the post office. I will send it Monday. Since the box was a lot of air, I included 12 issues of Railroad Model Craftsman to fill

Hi Larry, I will put the check in the mail tomorrow and there is no hurry about getting the cables as I am a long way from hooking up the wiring. I am using a resistance soldering unit to make a

Larry, The actual invitation was issued to David Smith in Huntington Beach but Yahoo Groups know no boundaries! Feel free to join from Texas an participate as an “internet” member.

I am very aware of ZoCal. I have been to many a show that your group was participatory. I live a little to far to be a member as my home is in South Central Texas. Larry