开云体育

ctrl + shift + ? for shortcuts
© 2025 开云体育
  1. YamahaDX
  2. Topics

LFO Speed in BPM and some LFO tricks [1 Attachment]

 

Hello Martin

Many thanks for the LFO parameter tables.
With regards to the DX11, on page 9 of the manual, the LFO --> Speed section states:

"At a setting of 35, the LFO will make 6.7 cycles per second and at 99, 55 cycles per second."

So looking at your table, the Hz value for the LFO setting of 35 concurs with that in the manual. There is, however, a slight discrepancy for the Hz values corresponding to the LFO setting of 99. Did you calculate the values according to some equation ? . . . or was this table obtained from a certain source ?

Many thanks,
Eb


On Tuesday, December 10, 2013 2:26 AM, Martin Tarenskeen wrote:
?
[ from Martin Tarenskeen included below]


On Tue, 10 Dec 2013, Martin Tarenskeen wrote:

> - As extra study material I used a specification doc for one of the Yamaha
> FM chips (google seacrh for ym2151synthesis.pdf) that contained a table
> with values. I have attached a page from this document to this mail.

Attached now :-)

--

MT
 

Okay right, I have just read your next message. Eb


On Tuesday, December 10, 2013 3:16 AM, Eb Mayat wrote:
Hello Martin

Many thanks for the LFO parameter tables.
With regards to the DX11, on page 9 of the manual, the LFO --> Speed section states:

"At a setting of 35, the LFO will make 6.7 cycles per second and at 99, 55 cycles per second."

So looking at your table, the Hz value for the LFO setting of 35 concurs with that in the manual. There is, however, a slight discrepancy for the Hz values corresponding to the LFO setting of 99. Did you calculate the values according to some equation ? . . . or was this table obtained from a certain source ?

Many thanks,
Eb


On Tuesday, December 10, 2013 2:26 AM, Martin Tarenskeen wrote:
?
[ from Martin Tarenskeen included below]


On Tue, 10 Dec 2013, Martin Tarenskeen wrote:

> - As extra study material I used a specification doc for one of the Yamaha
> FM chips (google seacrh for ym2151synthesis.pdf) that contained a table
> with values. I have attached a page from this document to this mail.

Attached now :-)

--

MT
 

Hi Martin,

I can not open the file. Any chance of sending a new link/re upload the file? Thanks a lot in advance.

1 - 3 of 3