开云体育

Thanks for that Nick, I have played around with these in the past with limited success. Also finding it difficult to switch quickly from one patch to another within a suitable time frame - whereas

You can help make any patches sound authentic to the music of these regions by using the microtuning feature found on page 50 of the XD7 II FD manual. It is also possible with TX802. There are a few

Does anyone know where I can find Arabic, Turkish, Greek sounds/voice or oriental voices for a Yamaha DX7 FIID? Have surfed the net for days, but have not been successful I know that Yamaha had added

On my DX7II, button 16 does nothing in Edit mode. It is not labeled on the front panel and nothing happens when you push it. There are 2 memory protection settings under button 14: one for

Hey, folks, I'm having a bit of a problem with my DX7IIFD. Note that all of this is me directing someone else, so there's been a bit of digging around. My cartridge sounds are fine, but the

Hello, folks, I've got a bit of a setup issue. I need to do the following things on my DX7IIFD: Set MIDI channels to 11 and 12 (I think this is on button 31) and make sure Local is on Turn Even/Odd

OK I think I can answer my own question. I opened up the DX7II sysex documentation. Table "5-2. Additional Parameters (ACED format)" describes voice parameters that are in the DX7II but not in the

As you may know, the DX7II and TX802 LFO's have a "single/multi" setting. According to the manual "multi" means that each voice gets independent voice LFO. I am scratching my head here because I have

I notice the TX802 MIDI Implementation doesn't mention Bank Select.? I'm not clear if that can be done as the usual CC 0 or sometimes CC32, but it doesn't say so. The "Full text of Yamaha TX-802

Hi Nicole, Here's the MIDI implementation chart for the TX802: TX802 MIDI Implementation Chart This is copied from: tx-802servicenotes_text.pdf, possibly introducing a few mistakes because the

Here's the text of the full KX5 manual, minus the FCC compliance section.? The last page is messed up, but the previous post covers that: Full text of "YAMAHA KX5 OWNER'S

I can't find the usual MIDI specification table for the KX5, but there's a scanned manual, with text added, and a separate specifications page.? The specifications page from the full manual seems to

Hi Nicole, This is from dx7IId-man.pdf, although the title of the table says Model DX7-2. Pasting from the PDFs, where they have text at all, leaves a jumbled mess, so I've re-written it in a form

Hey, everyone, does anyone have the MIDI Implementation Charts for the DX7IIFD, TX802, and KX5 in a non-graphical format? I'm updating some information on my master gear list. Thanks for any help

Hi everyone. Connecting the click out to the audio interface input, I can hear a distinct current sound and a faint metronome sound, the metronome sound varies in speed depending on the bpm. But the

Maybe Sweetwater?

Thanks for the tip! To tell you the truth, I've never programmed an FM synthesizer before, so I'd need a serious learning curve :) With the oscilloscope, I thought that at least I could find out if

The oscilloscope was fun but it did not teach me much in the end. It was mainly by carefully listening and editing patches that I convinced myself that the OPS2 was working and that the EGM had to be

Thanks for your suggestion, I read it, I also think there is a hardware problem. I have a good DX7S motherboard that uses the same chipset, I'll start comparing the signals around the two big chips

Thank you Florian for your reply. The error occurs even in test mode, when only the 880Hz sine wave sound should be on the output, which makes me think that it is definitely a hardware problem, not a