开云体育

I'm going to write an FT-980 driver for flrig. This will allow GUI control of tuning, IF? Shift and the other "locked out" functions. As Wald pointed out, for FT-8 (or any of the modes supported by

All, Please correct me if I am wrong... my understanding is that the way Yaesu implemented CAT in FT-980 mandates the front panel controls to be locked out for any CAT transactions.? So are you guys

I played around with hamlib for a bit, submitted a change, even started work to improve the interface. The biggest issue with the FT-980 I found is that most of the front panel interface locks out

Dear all, I asked a question to the Hamlib mailing list and got the

All, I've been doing a bit of rig driver development for flrig over the last few months. Absent from its list of supported radios is the FT-980. As soon as I finish the Optoelectronics scanner

Kenichi San, I also experimented with FT-980 CAT functionality and determined the following: - WSJT-X program works well with this radio? (tested on Windows 10)- none of the popular logging

Thanks JMat for various information! I made similar observation on the log. After that, I looked into the source code of Hamlib library and found that if I replace the

Hello Kenichi, I'm not an expert un CAT for FT-980, but in the past I tried using Omnirig and Omirig Client. The details of CAT protocol are given in page 13 (page 15 of PDF) in service manual

I am fascinated to find a thread in this FT-980 group to discuss CAT connection to FT-980 using Hamlib library. I am now trying to do it myself. However, when I try to use rigctl in the Hamlib

EA1FC, Thanks for your previous post.? I appreciate the info. I have been looking at the Q03 in the RF unit. Is that the one you meant.? It is the large one near the front corner.? In GEN the

Hope you all had a pleasant Christmas holiday I've finished re-furbishing the PA unit following previous owners terrible mess. Two questions please: (i) The final amplifier bias is adjusted by

Many thanks Bob - I'll take a look tomorrow - but I may have to consult you a bit further down the track! I want to change the two smoothing caps. Kind regards Peter G0LQU bthola@... wrote:

I don't have any other documentation but the rear cover plate over both units is removed with 6 screws.? Once the cover plate is off there are 4 screws holding each unit in.? These 8 screws are

Hello I need to remove the power supply and power amp units from the back of the radio. I have the user intructions and the technical supplement but they do not cover this area. Is there any more

I don't mind you pointing out the obvious.? I will take any suggestions I can get.? I was aware of the MOX button and had checked it.? I will attempt some of the voltage checks you suggested.

Hi all. I have a very early FT980 (in fact I have two - one with an Rx fault with LSB and one with a Tx fault - intermittent RF power out). For the Tx problem rig, when I Tx using FSK mode with 50

Sorry for the obvious that follows, but it has happened to me before hahaha. There is a MOX knob that puts the radio in transmision without pushing PTT. If it is pushed in, the radio goes in TX

This is definitely not a Tx/Rx issue.? I have not even attempted to transmit since Nov. 14th when the first problem appeared with the C20.? Everything seems OK until I switch from GEN to HAM and

As far as I know, nothing changes in the PA while in reception HAM or GEN. Maybe you mean in transmision. Then voltage TX13.5V appears (13.5V line is allways present for drivers and finals

I replaced the two resistors in question and now some else smoked.? It worked fine in GEN but when I selected HAM it smoked briefly.? I cannot see any damage or figure out with component caused the