开云体育

ctrl + shift + ? for shortcuts
© 2025 开云体育
  1. Yaesu-FT-60
  2. Topics

Transmit pl problem

 

I am trying to access repeaters with pl on 443mHz. The pl is turned on and proper shift. I searched the pl tone with another radio and it came up with the correct tone being transmitted. But I cannot access the two close machines near me. Is it possible the tones level is too low? My Kenwood ht accesses both machines ok.

Thanks
Gordon kc2bw
 

开云体育

I would check to make sure the tone is set on the transmit side and no tone on the receive side. ?Is there any receive light that comes on after you key up then release the repeater? Can you hear the transmission come through on the Kenwood? ?Do you have a +5.00 offset turned on? ?Receive on 443, transmit on 448?

Jardy Dawson WA7JRD

Message sent by....Oh, who the heck cares, anyway? ?Could be my shoelaces, as far as I care!


On Mar 20, 2020, at 12:18, Gordon Smith <kc2bw@...> wrote:

?I am trying to access repeaters with pl on 443mHz. The pl is turned on and proper shift. I searched the pl tone with another radio and it came up with the correct tone being transmitted. But I cannot access the two close machines near me. Is it ?possible the tones level is too low? My Kenwood ht accesses both machines ok.

Thanks
Gordon kc2bw
Scott ..
 

Gordon,

I have that radio. the manual makes a simple job difficult. Be sure you are not reading too much into it.?

73 de Scott/n7net


On Fri, Mar 20, 2020 at 2:18 PM, Gordon Smith
<kc2bw@...> wrote:
I am trying to access repeaters with pl on 443mHz. The pl is turned on and proper shift. I searched the pl tone with another radio and it came up with the correct tone being transmitted. But I cannot access the two close machines near me. Is it? possible the tones level is too low? My Kenwood ht accesses both machines ok.

Thanks
Gordon kc2bw

1 - 3 of 3