开云体育

The Heil headset works fine here with both my FT-60 and FT-70. Make sure the plug is firmly seated in the jack and the mic element is close to your mouth. Also, the two ends of that tiny

You shouldn't have to adjust the deviation.?Are you sure the plug is FULLY seated in the jack?73,Gary K9GS

Thanks Clint, I'll look into that. 73 Gary KF0RKF

Thanks Gary. It doesn't have a bettery, but someone else suggested adjusting the TX deviation. I'll look into that. 73 Gary KF0RKF

Hi Clint,Does the FT60 supply DC bias for the microphone element or is there a battery holder in the headset?73,Gary K9GS

Have you messed with the TX deviation setting? That Heil setup has worked for me for many years. -- Clint Bradford K6LCS http//www.work-sat.com

I'm not familiar with that headset but specs show an electret microphone element which must have bias applied to function.? I don't think the FT60 supplies bias.Is there a place to put in a

Does anyone have a suggestion for adjusting mic gain on the FT-60? I need to increase it to use a Heil HTHY headset.

I put the Heil HTHY on my Yaesu FT-60. The earpiece sound quality was very good. However the mic gain was low based on the signal reports I received. Since the FT-60 doesn't have a mic gain setting, I

Good afternoon?I have the Heil HT-Y and love it.Otherwise I use a Yaesu lapel mic but forget which model.73FrankKB3PQT?Sent via the Samsung Galaxy S24, an AT&T 5G smartphone

Try for a single headset with a noise cancelling boom mic attached, so you are speaking directly into the mic. That's my .02 worth. Yep, for example, HEIL HTH-Y

It picks up background noise and the voice is hard to understand in some situations.? Try for a single headset with a noise cancelling boom mic attached, so you are speaking directly into the mic.?

Most states will allow an earpiece in ONE ear while driving. Suggestions

I'm looking for a new microphone for my FT 60 for use in the car and since I'm pretty deaf in one ear I thought this lapel mic earpiece might be a solution. Has anyone used it? What can you say about

Hi Jayne, I am no expert, but some chargers for Nicad and NiMh cells turn on the "charged light " - which may be green color, when the battery voltage exceeds a certain threshold. These chargers do

" Once it drops below 7.6V I can't transmit. This just seems rather odd, " I don't think that is normal.? Under load, you really can't expect 6x NiMH to maintain over 7V. My problem is that no

The reading when I turn the HT on straight off of the charger is 8.6V. I have it attached to a Signal Staff OSJ collapsible J pole. I use the standard FNB83 battery. I'm using the standard Yaesu drop

Sounds like bad batteries or a bad charger. When you first turn the radio on, what battery voltage do you read? I have 2 FT-60s. They both have been charged in the last few weeks, but not used since

Yes, what Clint said! He's an authority on the FT-60.? I only use Powerex Pro NiMH? AAcells in TWO FBA-25 alkaline cases, so there's always a fresh backup.? Much more economical than buying

I have owned several of these since the moment they were released 18 years ago. Each performs as if they were brand-new ... I mainly use 2700mAH AA NiMH cells in the FBA-25 alkaline case - and charge