开云体育

Purchased replacement battery ! Wd9dnm

I am sorry if I overlooked this answer somewhere else. I just purchased my first ft-60 and wondered if it was best to let the battery "completely drain" before recharging, and just re-charge when the

I've found the Energizer 2300mAh NiMH to be a little tough to fit in some other unforgiving AA battery compartments. ?The unfortunately _incredibly_ tight battery pack fit on this HT would make

The ARS function is explained on page 19 of the manual. It can be turned either ON or OFF in set mode item 4. 73, David - G4EDR

Hmmm ... I know it's sometimes a tight squeeze ... and you know there's a thin rubber gasket along the outside edge of the case ... Please let us know your results. I have used alkalines from Amazon

Thanks for the reply. I tried installing some Energizer 2300 mAH AA batteries. I believe they were fully inserted. The battery holder still would not seat properly on the radio. Maybe I'll try a

Insert the batteries negative-side first, and make sure that when you press against the positive end, that they get fully inserted. -- Clint Bradford K6LCS http//www.work-sat.com

I picked up the AA battery case at Dayton.. I put 6 Duracell AA batteries in it and can't really get the battery clip to latch. Is there that much variation in AA battery dimensions that some work and

Once you have your frequency entered, press F/W followed by 4 (RPT). Now, turn the encoder knob on top until you hear a beep. F/W again to exit. I’m blind, so that’s how I do it. Sent from

Thanks. My connection issue is resolved. -- 73 Al McManus???? KN6ZVI San Martin, CA

Can someone give me directions on programming this radio for simplex? I cannot seem to turn off the ARS function! I can program for repeater use but simplex? ... I give up. -- 73 Al McManus????

I thought you had a well written piece there. -- 73 Al McManus???? KN6ZVI San Martin, CA

Here's my take on programming and memory banks:?http://www.winterwren.com/HamRadio/RadioProgramming/HamRadioProgramming.html

Good evening I am not sure by what you mean by all the steps it took to start scanning in a memory bank......... I turned my FT60. Made sure it was in memory mode. It was scanning bank 1. It

I'm glad you commented about the loss.? I can't count the times I have heard that connectors add loss, anywhere from 0.25db up to 1db per connector. Jim W6LG, has a couple videos on his YouTube

100% agree with you Clint.? The CN-3 adapter and the same adapter made by other companies are a great way to damage the SMA connector.

UPDATE: I found what I needed to know, sort of, in the manual after all. I am unclear though; if I am scanning in a memory bank and I interrupt the scan by pushing PTT to listen do I have to go

Has any got a way to learn how to scan certain bands in memory that they can teach me? I am very visual so if you know of a You Tube or other video that would be best. Thanks -- 73 Al McManus????

Do NOT go into the lights! -- 73 Al McManus???? KN6ZVI San Martin, CA

Photo link gave an error 404 file not found. FYI JIC. -- 73 Al McManus???? KN6ZVI San Martin, CA