开云体育

Glad you got it sorted. -- Gary KY8M Macomb, MI.

Be careful measuring high frequency on an oscilloscope, the input capacitance comes in to play and severely derates the maximum voltage capability.

Gentlemen, Thank you for your assistance. I have determined that the packs are fine -- well, as fine as one can expect for their age -- and the radios put out between 4 and 5 watts. The problem was

So what readings do you get when you use the ext power jack? -- Gary KY8M Macomb, MI.

You can set the transmit power level. If I remember correctly, if the power level is set higher than the battery can support, the voltage collapses & the radio powers off (& perhaps back on?). That's

This is nothing so sophisticated, I far. I am measuring the power out with a watt meter. (Technically, a scope and a voltmeter; so O am reasonably certain sure of the accuracy.? In fact, the issue

I know on my 60R there a a auto power saver that when you are hitting a repeater on high (5W) power, and you don't need 5W it cuts the power level back. Maybe when you measure your output with a watt

I have two venerable VX-150s (opened up for CAP use) and an FT-60R and have been charging them on the SBH-13 battery charger. Of late, I have noticed that in high power mode, all three are only

The big question: what unusual conditions did the failing gaskets experience? Temperature extremes? Mechanical wear? Solvents? Mine are as good as new. [email protected]> wrote:

Dale, thanks for note. I ordered it from there. It looks good so hope that I will be happy as same as you are…hi. rgds, 73 - Petr, OK1RP

If not available from Yaesu Parts, I would ask BatteriesAmerica.com I have several from 2004-onward ... never a problem. -- Clint Bradford K6LCS http//www.work-sat.com

Have you contacted Yaesu? That’s the first place I’d try. 73 de AC7EW Kelly Sent: Friday, 10 March, 2023 15:46 To: [email protected] Subject: [Yaesu-FT-60] Replacement gaskets for

Is your external mic jack cover still good? I had a lot of water get in mine due to a major downpour. Fortunately, the radio dried out with zero problems afterwards. Jardy Dawson WA7JRD Message sent

Does anyone know of a source for the battery pack gaskets?? They aren't made well enough to outlast the batteries, unfortunately.? My radios are getting damp inside in drizzly weather.

I don't know if it's still available, but years ago I modified the leather case for a VX-150 to accommodate the FT-60.? It was a simple mod almost anyone could do. The mod instruction instructions

I couldn't find a Genuine Yaesu case, however I did buy this one from Thailand, it isn't amazing but it does the job and the only option I could find. The seller was very friendly and it arrived

Hi folks, as I did not find the genuine leather case dedicated for FT-60 in the brochure, manual or even on the Yaesu web > may I ask if somebody tried the YAESU CSC-68? Does it fit for FT-60

I understood the last paragraph.? Sent from AOL on Android On Sun, Mar 5, 2023 at 2:06 AM, radellaf<radellaf@...> wrote: Six 14500 LiIon (3P2S) would be double the mAh of the 1500

Six 14500 LiIon (3P2S) would be double the mAh of the 1500 standard NiMH pack. ?1250mAh 3A cells are available ~$3ea in low qty. Charging could be faster below like 70%. ?No heating up when topping

Both of my FT-60E charge the battery via the DC-In socket however I do not use it. The internal charger circuit is rather very rudimental. There is no end of charge termination implemented. It is