Just a thought...
These look like the instructions for recalling a memory bank for
use rather than assigning channels to a memory bank.
73, Nick, AA3T
On 8/2/2024 8:36 PM, CalFire via
groups.io wrote:
?
On Fri, Aug 2, 2024 at 05:13 PM, CalFire wrote:
Andy,
?
Never got your "example". It's O.K., I'll contact R.T.
Systems...again.
I did find this R.T. Systems tutorial but the enclosed, from
their PDF. See Page 80 in the link below. The snip below makes
no sense to me...
?
?
"Now that you have pressed and held the [BAND] key until
NOBANK appears,
you must keep moving. The radio will exit that mode rather
quickly. No
problem... just press and hold the [BAND] key again. Turn the
KNOB on top
to select the bank you want to use. Banks with a
number that does not blink
contain
channels. A blinking number indicates an empty bank that
cannot be
selected.
Once you find the one you want, press
the [V/M] key to save the
selection. If you want to be sure your selection was saved,
press the [V/M]
key to go to VFO mode then again to return to memory mode. When
you
return to memory mode the radio will display Bank # indicating
the working
bank.
So, that is a lot to sort through. Briefly, your key presses
are...
[BAND] (press and hold)
Turn KNOB to select the bank you want.
Press [V/M] to save
The radio will now operate as if it is programmed with only the
channels in that memory
bank"
?
?
"A blinking number indicates an empty bank that cannot be
selected."
?
ALL MY BANKS BLINK! So I can't use any of them? I just did a
factory reset!
?
How can they be unusable if I just did a factory reset? How
can a bank be "empty" and be unusable??
--
Sent from laptop
