开云体育

I uploaded part of a Fujisoku catalogue the Parts Database folder in the files section.? Fujisoku 8H2011 Rocker Switches as used in the FRG-7. See page 4. You may have to take a measurement as they

I took another look at eBay. See item 124299468972. It appears that the same seller has red switches. He also gives away the manufacturer in his pictures. The pictures show the red toggle removed from

Hi Roger, Its the red bit I want, the switch is fine but the red piece is very wobbly and can be easily pulled off the switch, I want to replace that with a tighter one. Cheers Steve

Hi Steve, Look at eBay item # 124331786820. Two switches for $15. The only problem is that they are grey and black. You may be able to remove the red outer section and put it on the grey switch. That

Has anyone got a spare on of these? Mine is very wobbly and about to fall off!

Hi Phil, Thanks for the update. Glad to hear it is all sorted out and that you you are enjoying the FRG-7! 73 Roger VE7LB

Hi Roger Just to close the circle on this.? My amateur friend restored the FRG-7 back to original spec viz the filter and discovered a dry solder joint on the IF board while he was at it.? Fixing

Thanks Roger I should have explained that the pictures show the filters now removed from the board. Since my posting I have enlisted the help of a much more technically competent amateur friend and

Hi Phil, It's hard to tell what's wrong from the two pictures. The only obvious thing is the bare copper wire not being grounded. It looks like it was under a screw head at one time. If that doesn't

Hello all My FRG 7 had a filter mod done at some stage in its life and I need some help to work out how to wire it up properly.? It's a long story, but while recapping the radio the filter, which

The following files have been uploaded to the Files area of the [email protected] group. * /FRG-7 with non GAR-7 Digital Readouts/FRG-7 KRS Display/KRS FRG-7 Displays.pdf (

Hi Rick, I think the brands were switched in production. Enjoy the FRG-7!? Roger

Thanks Roger for the reply ,checked the solder side of the board and every thing looks clean and smooth ,if those caps were replaced they did a very neat job ,I just thought with the two different

Hi Rick, The most important thing that you can do with your FRG-7 is to make sure the fuse in the rear holder is 1/2 amp and no larger. If a problem develops with a main filter capacitor the fuse will

Hello my name is Rick new to this group ,I got a FRG-7 from Danny in Quebec that looks and works like new ,I found a website that shows you how to find out when the set was made ,my ser. # is 6M081728

I previously added some information about the S & S Engineering Digital Readouts to the Files Section "FRG-7 with non GAR-7 Digital Readouts" folder. There is presently an eBay seller with four of

Hi, Page 51 of the FT-757GX service manual lists two pilot lights. One for the VFO and the other for the meter. A free copy of the service manual is available at

don't know if there is a forum for the FT 757, so will give this forum a try. Question. Does anyone know if the FT-757GX II have a back ground light for the S meter?? Since my unit has none I'm

Yeah wouldn’t it be great to have all the promised content. So hard to find info for equipment that predates the internet Yet there must be radio fans out there sitting on a goldmine of printed

I recently added several FRG 7s to my receiver collection and while both are fairly minty cosmetically one of the units has an issue with the main KHZ tuning drum. It seems to hit the limits before