开云体育

Thank you Lex

The FRG-7 display is in production. For the RA-17 I would like to 3D-print the housing of the S-meter, with the display integraded. Like with the FRG-7, it is my goal to bring it back to its original

That is awesome, I am sure these will be very popular. I want two when you are in production.? The display is likely a tad small given the bulk of the Racal RA17 front panel, I would envisage it

Nice modification, -- 73 Lex PH2LB https://www.ph2lb.nl/

Hi, In a previous post, I've announced that I was making a new kit for a digital readout with also a MHz indication. Now I've assembled the first PCB's and they function?well. For an impression,

Hi, I have my FRG-7 for sale. It is an early version without the "fine tune" control. It is in good condition for its age an works well. I am looking for offers near ?150 and it will need to be

Marcel, that is excellent work. Just a suggestion to increase the versatility of your design dramatically. As you know, the VCO frequency of the FRG 7 runs from 55 to? 85 mHz with a 55mHz 1st IF. The

Hi Marcel, It looks good and I am glad you got it working well. I am looking forward to buying one.

Hi Chris, Coming back to your question concerning the MHz readout, it seems my proto is working well. I could stay to the Arduino, but I had to squeeze everything out. I'm now at 99% of the memory. I

One more… this one for $4.99 is cleaner and even closer! It’s called “Bebas Neue Semi Rounded”. Link: https://www.myfonts.com/products/regular-bebas-neue-semi-rounded-204747 73, Randy

Addendum… screen shot for “Redgar Clean” by Graphite (link in previous post):

Hi gbrandy and Randy, thanks for your reply. I'll give a try. 73 de PA8MA Marcel Op vr 28 jun. 2024 15:21 schreef Randy K7RAN via groups.io <k7ran= [email protected]>:

The font “Redgar Clean” by Graphite is a $12 font that comes pretty close! Note the serif on the number “1” as well as the curves on the 3, and 5, and the straight vertical sides of the zero.

If you can get a reasonably detailed picture of the dial, there are several web sites that can try to identify the font from a picture you upload to them. I believe I’ve used this one in the past:

Hi Chris, yes that is my goal. But it is more effort then expected. The Arduino run out of memory and the speed is too low. So I have switch to an ESP32. And a redesign of the pcb. Op wo 26 jun. 2024

Hi Marcel, Does this version have the Mhzas well as the Khz readout?

Hello, I'm working on a new version of the digital readout. Does anyone know which font has been used for the dial in the FRG-7? Regards, Marcel de PA8MA

The mind boggles at some of the "mods" you find, most are just a bastardisation. This one appears to route DC through another fuse to the RCA connector at the back. The rest appears to be a tapping

There's a small board located on the underside of the RF board. I assume it's some type of mod. There are 2 RCA jacks added on the back skirt of the receiver. Labeled VFO and PWR Wonder if anyone is

Well again thanks much for your help.. As an industrial electrician for years I understand exactly your previous comment. I guess it would be bad juju to say i hope it fails again but... maybe