开云体育

This radio started as a very neglected FRG7, too rough to repair, too good to throw out. With the help of an angle grinder, the top chassis section was removed, and new alloy chassis plates fitted.

OK TNX! 73 Wilbert PA3DAE

Like said it isn't a original knob and but a after marked one installed by many owners to have a more fine /? course tuning posibility. I have seen this on aprx 50% of the sold FRG-7's in the

Do the knobs rotate at different speeds? If so there may be better fine tuning using the inner knob. 73 Roger VE7LB Sent: Tuesday, March 7, 2023 5:44 AM To: [email protected] Subject:

That is not the original knob

Hi, Can anybody tell if this Sommerkamp FRG-7 tuning knob is an original design for this receiver? I don't see any pictures on the internet with this kind of tuning knob. Tnx! 73 Wilbert

That add on is an NFM demodulator, this radio has been used as a tuneable IF for VHF convertors..

My upgraded FRG7,

Ed Shaw was a well known DXer in the 70s and 80s and had a column in NASWA I found a column in which he described the mods he did on his FRG7 I put it in the mods folder, check it out

MikeM <mmaghakian@...> added folder */7 - FRG-7 Mods/Mods from Ed Shaw* --- The following files and folders have been uploaded to the Files area of the [email protected] group. * /7 -

If memory serves me correctly it was to deal with microphonics

Fellow Frogers, Just picked up a new-to-me FRG-7 and noticed what seemed to be an unkown mod consisting of a DPDT slide switch (S-7) w/ two? resistors (R-18 & 19), connected to the internal

Hi Andrew, The FL-101 transmitter looks very similar to the FRG-7. But when the FL-101 is used with the FR-101 the pair will work in transceive mode after the interconnecting cables are attached. 73

I am looking for an aftermarket speaker replacement for the main speaker on the FRG-7. Has anyone had success with finding one?

Thanks, Lex, for that 3D-printed knob design. I was lucky enough to find an original knob on eBay. Also, thank Cesar for your reply. This is one neat radio. I am researching a suitable AM transmitter

The knobs of the first model FT-101? look like the on a FRG-7. But the knobs you are pointing to in the e-bay link are from the newer models of the FT-101 (E, ET, Z, MD etc) and look like the one's

Read that ft 101 is the same. Found

Hello Andrew, These are very hard to come by. I had the same problem and often 3D print parts, I designed my own (as close as to the orginal as

Wondering if anyone has the main tuning knob they would be willing to sell? Andrew

I should have mentioned my goal is to replace the kHz drum with a 3 digit display