开云体育

But why would it get worse when the radio is on? I checked all the joints, they look fine.

Hi, sounds exactly like a bad solder joint. Probably at the pcb end. If your handy with a soldering iron, it should be an easy fix.? Hope this helps.? Bob On Wed, Aug 3, 2022 at 8:03 PM,

Hi there. My friend very kindly gave my his old FRG-7. It works really well and I love it! It has one problem. The lock Led will not work, unless the radio was turned off and sitting for a few

Levers arrived today, so quick ! thanks so much !

I can send a set of levers for Euro 2,65 (send as letter). Bigger parts (up to 350 gram) which fit in a letterbox package shipping will be Euro 11,50. -- 73 Lex PH2LB https://www.ph2lb.nl/

Yes, what is the cost including shipping to the USA for the red lever thanks

When you want to work on your "Franken-frog", I do have "body parts" in stock to fix the monster ;-) I have a original volume knop and S-meter in stock. Fill this form and add to you comment field

well, my FRG-7 arrived today poorly packed and the volume knob smashed the power cord cut the S-meter seems stuck it does receive there is only one possible use for me the creation of FRANKEN-FROG

Thanks, the FRG-7 I purchased still has not been shipped and I am waiting until I receive it before buying anything for it. Mike

Mike, I have send you a private message, but maybe it's stuck in a spam filter. When you still need the knobs I can send you a set in a envelop. Fill in my order request form :

Washington state USA

Mike, where are you located ? -- 73 Lex PH2LB https://www.ph2lb.nl/

let me see what develops, thanks for the offer !

Sorry my 3d printer friend decided to leave Calif.? So I haven't found another.? I do have a Grey switch lever though if you can use it let me know. 73 Bob

Do you have an update on a switch lever ? I need a red one

Yes, that's all it was... just needed a tickle of VR102 so the lock light was less fussy.? Thanks!

I'm curious about the design the 3D printer is using. I have designed spare parts for my FRG-7's and made the files are publicly available (for non-commercial

I have found a possible source for FRG7 switch handles.? This 3D printer made me a spinner knob and it works perfectly. Will let everyone know when? I get a quote. Bob

My lock light would not light up when I ran the FRG 7 on internal batteries. Member feedback suggested I had to adjust VR102 until the lock light would then come on for each band. Maybe that will

Hi all, My recently restored FRG-7 has developed a slightly annoying problem.? When cold, the 0, 1 & 2 MHz bands won't light up the 'lock' LED.? After some time warming up, the 0 & 2 MHz bands will