开云体育

Hi fellows thanks for the help , I like the W6LVP but the price is a bit high at $295.00 for the unit and $100.00 shipping , I live in Canada in Ontario and would have to check the cost for

I've tried several loops that really helped drop the noise floor but varied widely in sensitivity.? My favorite is the W6LVP active loop.? It has a low noise preamplifier on the loop powered by an

Hello Rick A few questions there.? Mini Kits does offer the option of having some of their products pre-assembled.? I am not sure if that is the case for the loop antenna module, but it may be

Hello Rubbersoul , if I buy the already assembled unit in an enclosed box I think I have to buy a loop antenna and coax cable for the unit ,I think , or could I just hook the unit to my long wire

Looks great. Thanks for posting. 73 Phil Sent from ProtonMail mobile

Hello Fellows , here is the website for the DD-103 unit , all I had to do was put on the two alligator clips , the fellow sent it to me set up for the FRG-7 , just put the black clip on the ground

Rick, does the unit display the MHz, as well as the KHz? Any photos of installation??? Thanks? Bob On Sat, Feb 5, 2022 at 12:52 PM, Rick<rdelaplante@...> wrote: Hello fellows ,just

Thanks for your information, Rick. This is the best kind of review to get. 73,Curt W4CP

Sounds great. Do you have a photo of it in action? Sent from ProtonMail mobile

Consider a loop antenna from Mini Kits in Australia. https://www.minikits.com.au/EME234-HF-Active-Loop They are low noise, reasonable in cost and work well. Some soldering required. Good luck Sent

Hello fellows ,just thought I would tell you , my Daughter got me a DD-103 universal Digital dial ,it is easy to hook up comes with the clips and wire and is set up for the FRG-7, just hook one clip

* *

I cleaned the switch 3 times as I suspected the same. Andrew

are you sure its not just a dirty band switch? ________________________________ Sent: Wednesday, January 12, 2022 10:57 AM To: [email protected] <[email protected]> Subject: [Yaesu-FRG-7]

When I put a signal on the antenna I’m able to tune in on the D & C bands but on A & B bands I can’t find any signal. I do hear a tone but it’s internal if I kill the signal gen it’s still

there radios are great receivers for AM shortwave and AM MW. a bit wide for ham radio SSB but still works if the bans are not to crowded ________________________________ Sent: Saturday, December 25,

Thanks ... I think my marks are bang on, so probably no need to do that.

I did mine a few years ago and dont remember it completely. you only need to make the adjustment if the Mhz is off. my radio was off by 1 Mhz, i had to set the Mhz dial either 1 Mhz higher or lower

Thanks! So what is the procedure to do that? I didn't find anything in the manual ...

you can use those marks to set & align the MhZ dial mechanical Stops on the drum ________________________________ Sent: Friday, December 24, 2021 6:41 PM To: [email protected]