开云体育

Consider a loop antenna from Mini Kits in Australia. https://www.minikits.com.au/EME234-HF-Active-Loop They are low noise, reasonable in cost and work well. Some soldering required. Good luck Sent

Hello fellows ,just thought I would tell you , my Daughter got me a DD-103 universal Digital dial ,it is easy to hook up comes with the clips and wire and is set up for the FRG-7, just hook one clip

* *

I cleaned the switch 3 times as I suspected the same. Andrew

are you sure its not just a dirty band switch? ________________________________ Sent: Wednesday, January 12, 2022 10:57 AM To: [email protected] <[email protected]> Subject: [Yaesu-FRG-7]

When I put a signal on the antenna I’m able to tune in on the D & C bands but on A & B bands I can’t find any signal. I do hear a tone but it’s internal if I kill the signal gen it’s still

there radios are great receivers for AM shortwave and AM MW. a bit wide for ham radio SSB but still works if the bans are not to crowded ________________________________ Sent: Saturday, December 25,

Thanks ... I think my marks are bang on, so probably no need to do that.

I did mine a few years ago and dont remember it completely. you only need to make the adjustment if the Mhz is off. my radio was off by 1 Mhz, i had to set the Mhz dial either 1 Mhz higher or lower

Thanks! So what is the procedure to do that? I didn't find anything in the manual ...

you can use those marks to set & align the MhZ dial mechanical Stops on the drum ________________________________ Sent: Friday, December 24, 2021 6:41 PM To: [email protected]

What is the purpose of the triangle marks at the extremes of the MHz and tuning dials? Thanks!

Well, this turned out to be quite a bigger job than anticipated. Apart from the usual electrolytic capacitor replacements, I also found all the mylar / polyester capacitors had delaminated - possibly

Hi Jason, That's good timing! I was just looking at that pdf (Files Folder #7 -? FRG-7 BFO Mod.pdf) and was about to suggest that was possibly what the previous owner was going to do. There have

Hi Roger, Thanks for the speedy reply! On closer examination, the original owner has done the ceramic resonator BFO mod and located the BFO on the underside chassis in it's own little shielded box,

Hi Jason, Lex - one of the group members is parting out an FRG-7. His website is https://www.ph2lb.nl/blog/index.php?page=for-sale-frg7-parts . I see one eBay seller in Hong Kong has sold 50 sets of

Hi all, Picked up a FRG-7 as part of an auction lot, and it's in need of a pretty heavy restoration - both cosmetically and circuit operation wise. First up will be electrolytic cap replacement and a

I put the KRS/Radio West FRG-7 info in the Files Folder /g/Yaesu-FRG-7/files/6%20-%20FRG-7%20with%20non%20GAR-7%20Digital%20Readouts/FRG-7%20KRS%20Displays about a year ago. The KRS

Radio west also sold a digital readout that replaced the drum Check out their catalog for their FRG 7 offerings and the other stuff they sold and how they modded

I forgot about the KRS version even though I put the KRS folder in the Files section last year!