开云体育

Hi All, I have recently got my hands on one of these and would like to make it look pretty again and it has not been looked after that well. Its all good from a functional point of view but some of

Hello John, Much appreciated. I have good measurement gear in my shack, including a boat-anchor Agilent 8753 network analyser :) 73 Dieter

Excellent. thanks Steve.

Hi Dieter Also in the files section "4 - FRG-7 Service Notes" there is a lot of useful info. The two magazine articles by Lindsay Hood are highly recommended reading re theory of operation and

Hi Dieter. take a look in the files section, you will find the manual, it’s a little challenging to follow without a scope in that range I measured my voltages the other week as I’m chasing issues

Hello FRG-7 friends I have purchased a relatively well preserved FRG-7 from a friend. I owned one as a young SWL and used it to learn CW by copying maritime CW broadcasts on HF. I wonder if there

Glad they're still on the air. Need to fire up my FRG-7 and listen in. I don't use it enough. [email protected]> wrote:

As an update to my earlier recommendations for listening to BBC World Service transmissions from Wooferton and external relay stations, I see that the Malaysia and Madagascar tx are no longer used.

So sorry to read your cynical view of SW Broadcast listening Mark; in my experience, as long as you can get a reasonably quiet receive on a long wire or a loop, you will find delights throughout the

If there was anything of interest to take in?I’d agree, alas there is just propaganda and fake American accents … This is doubtful to enrich your grey matter.. Best 73Radio (a sad demise but it

I actually agree with everything you said and very strongly agree that movement/Gym/walking is priority but what I'm doing here is to also exercise my mind and keep the fundamentals of

You will soon get fed up with it… I’m licenced and I’m Afraid you are now better off going to a gym or exercising of some type to keep healthy.. Sitting around a radio in 2025 is the most

I'm quite lucky up here on north west UK, there are still some broadcast stations to listen to and the odd Ham as well, however, I'm enjoying the experience and 're-learning' a lot as

But John?There is nothing left to listen to anymore Sent from the all-new AOL app for iOS

Got it, there is a flat tension plate behind the front panel, remove the panel, clamp the shaft and you can increase the drag on the clutch. Cleaned all the muck out and ts much better now. Looks like

Good day all. Question, how does the preselect drive clutch work please, has anyone had to adjust it. I have some backlash that seems to be within the clutch mechanism, the output shaft to the toothed

Started again from the beginning. 1. stripped out the 2m converter, completely rewired the antenna connections and removed a pair of 1meg resisters from So239. 2. stripped the Band switch and cleaned

Good day All. I have a TinySA that have been using as an RF sig gen and a Zeewiie DSO1151g scope that 'should' run past 100Mhz, well lets just say 30Mhz is about its limit, this means I'm unable to

Hey Mike. Changed it today, nothing wrong with it, took the opportunity to resolder the joints around the area, no difference. Will retake measurements of all TP again tomorrow and may crank up the

Indeed, I get 112mV as well at the junction of R117 & R118. So something is shorted to ground here. R118 perhaps? Sent from Mike's iPad