Yaesu HF Transceiver, Desk Microphone,
and Power Supply For Sale:
.
Yaesu FT-840 HF Transceiver:
The compact Yaesu FT-840 has two direct
digital synthesizers and rotary encoder that
provide silky-smooth tuning. The excellent
general coverage receiver tunes .1-30 MHz
in 10 Hz steps. The FT-840 uses a die-cast RF
power amp with thermally switched fan to
ensure up to 100 watts output.
Other features include backlit 10 Hz LCD, IF
shift, reverse CW, dual VFOs, 100 memories,
attenuator, noise blanker, meter, scan modes,
automatic antenna tuner, and speech processor.
9.5 x 3.7 x 7 inches.
Requires 13 VDC at 20 Amps.
Features:
0.1-30 MHz Receive
100 Memories
LCD Display
IF Shift
Noise Blanker
Adjustable RF Power
100 Watts Output
Automatic Antenna Tuner
Attenuator
Dual VFO's
Squelch
This particular unit works like it should.
Cosmetically, it is exceptionally good.
It has one scratch that you can see if the
light is just right.
With paper work for $425.
.
Yaesu YM-38 Deluxe Desk Microphone:
The Yaesu YM-38 is a deluxe goose neck
type desk microphone. But it is more than
most microphones.
The PTT switch also has a locking position.
It has Up, Down, and F/S switches.
It can be used on most any rig since it has
a switch for 50 K (high) impedance, or 500
ohm (low) impedance.
This one presently has a round 8 pin connector,
obviously wired for Yaesu, which makes it
usable on TenTec as well as other rigs.
This one has the mic element replaced with
a Heil HC-5, which is Heil's mic element
with extra "punch" for working DX.
This particular unit looks like new cosmetically,
with no scratches or defects. It also works
perfectly.
Buy it with paper work for only $120
.
Kenwood PS-430 Power Supply:
I know it is not Yaesu, but it works great
with the Yaesu FT-840 above.
The Kenwood PS-430 power supply provides
13.8 VDC at 20 Amps intermittent. Ripple
voltage is less than 20 mV at 13.8 VDC and
15 A. Input is 120/220/240 VAC.
This is a linear power supply, so no need to
worry about noise from a switching supply.
The rear panel has a hardwired Kenwood
power cable (6 pin molex connector) to connect
directly to the TS-120/130/140/430/440/450
and others. Actually it will work fine with any
rig that uses the 6 pin molex plug, including
Icom and Yaesu and others.
There are also "plus" and "minus" terminal
outputs (10 Amps max) on the back, useful for
a VHf/UHF rig.
A snap-down tilt bail is on the bottom panel
to increase the operating angle.
6.8 x 3.75 x 9.675 inches 15.4 lbs.
This one works like it should, with great output.
Cosmetically it is average. Not exceptional
like most of the gear I sell.
With paper work for $100
.
Original Yaesu Manuals:
These are the manuals only. All are originals, and not copies.
Most are in close to new condition.
FNB-9,10,11,12 Battery packs, $2
FC-757AT Antenna Tuner, $10
FT-100 HF/VHF Transceiver, $18
FT-470 Dual Band HT, $10
FT-757 GX, HF Transceiver, $18
FT-720 R, 2 meter mobile, $8
FT-1802 M, 2 meter mobile, $12
FT-2700 Dual Band Xcvr, $12
FTH-2005 HT, $5
FTS-8 tone squelch unit, $3
FTS-12 tone squelch unit, $3
MH-1B A2B speaker microphone, $2
SP-101 P, Speaker / Phone patch, $5
VX-1 dual band HT, $10
These are original Yaesu operating manuals only,
in very nice condition.
.
I also have many other accessories available such as many
different types of microphones, HTs, VHF and UHF rigs, HF
and VHF/UHF antennas, connectors, miscellaneous accessories,
etc.
Just too many to list here. Please e-mail your requests.
.
Prices do not include shipping from Florida.
Thanks.
73,
Ken, W8EK
Ken Simpson
E-mail to W8EK@... or W8EK@...
Voice Phone (352) 732-8400
.
